Panasonic KX-TC1201BXB, Руководство пользователя, Страница: 38 / 77

JK1 (3): T L6 R144 IC3D (12,13 14) C97 R148 Q20 IC2 (24) [BELL]
JK1 (2): R L4 R120 R152
When the CPU (DSP) detects a ring signal and press the TALK Key on the handset. Q6 turns on
and then RY1 turns on,
thus providing an off-hook condition (active DC current flow through the circuit) and the
following signal flow is for the loop
current.
T R160 L4 RY1 R107 T7 R116 D5 L6 R161 R [OFF HOOK]
ON HOOK Circuit:
Q6 is open, RY1 disconnected as to cut the DC loop current and to cut the voice signal. The unit
is consequently in an on-hook
condition.
Pulse Dial Circuit:
DSP (Relay) turns RY1 ON/OFF to make the pulse dialing via Q6.
Make/Break ratio when dialing with the Handset: 40%:60%
Side Tone Circuit:
Basically this circuit prevents the TX signal from feeding back to RX signal.
As for this unit, TX signal feed back from Q11 is canceled by the cancellor circuit of AGC.
16.6. Transmitter/Receiver
Base Unit and Handset are mainly consists of RF(Radio Frequency) IC and CPU.
Base Unit and Handset transmit/receive voice signal and data signal through the antenna on
carrier frequency.
Signal Pass :
*Refer to CDL TX/RX in
Signal Route ().
16.6.1. Base to Handset
Circuit Operation:
The voice signal input from the TEL LINE interface goes to RF IC as shown in
BLOCK DIAGRAM (Base Unit) ().
In the talk mode (off-hook) condition, the telephone line voice signal passes through D2, D3, D4,
D5, RY1 (Relay), R107 and T7.
38