1.23 Extension Controlling Features
Feature Guide
163
1.23.3 Walking Extension
Description
It is possible for an extension user to trade extension settings with another extension.
When Walking Extension is executed, all extension settings (extension number, Class of Service (COS),
One-touch Dialing memory, etc.) of the "old" extension are exchanged with the "new" extension.
This feature is useful when an extension user moves desks, or when an extension user has no permanent
desk.
This feature is also known as Walking Station.
Conditions
•
This feature is available by switching the telephone between proprietary telephone (PT) and PT, single
line telephone (SLT) and SLT, PT and SLT. Moving across the tenants is also possible.
•
Incoming calls to your extension will reach you at your new location.
•
An extension personal identification number (PIN) is required to use this feature. (
→
Personal Identification Number (PIN))
•
If a DSS Console is connected to a PT and the DSS Console is continuously used with the PT after the
Walking Extension has been performed, the new extension number of the PT must be assigned as the
paired extension through system programming (
→
Console Paired Telephone [007]).
User Manual References
1.23.4 Timed Reminder
Description
An extension can be preset to ring at a certain time, to act as a wake-up call or reminder. This feature can
be programmed to activate only once, or daily. If the user answers the alarm call, a special dial tone or a
prerecorded voice message will be heard.
Timed reminders can be set in one of two ways:
•
By the extension user, from his or her own extension.
•
Remotely, by the hotel operator (Remote Wake-up Call)
Conditions
•
Be sure that the PBX clock is set to the correct time.
•
Only one timed reminder can be set for an extension at a time. Setting a new reminder clears the
previous reminder. If both the extension user and the hotel operator set a timed reminder for the same
extension, the timed reminder that was set most recently is effective.
•
Programmable Time
The Alarm Ringing time, the number of alarm repeat times, and Interval time are programmable through
system programming.
•
To use the voice message feature:
An MSG card is required and a message must be recorded. An extension assigned as a manager can
Содержание KX- TAW848
