ConnectionWall Mounting
16
Document Version 2007-06
ConnectionWall Mounting
1.
Remove the wall mounting
adaptor from the unit as
shown.
2.
Set the operation board to
level 1, then connect and
secure the cables. Next,
attach the wall mounting
adaptor as shown.
•
The cables can also be run
from the top of the unit
(page 14).
•
Make sure the cables are not
pinched by the wall mounting
adaptor. When running the
cables from the top of the unit,
look through the opening in
the wall mounting adaptor (
A
)
to confirm that the cables are
not being pinched.
3.
Drive the screws (included)
into the wall, and mount the
unit on the wall as shown
below.
•
Mount the unit in such a way
that its weight (1.5 kg [33.07
lb]) can be supported.
•
Make sure the cables are
securely fastened to the wall.
•
You can find a measurement
guide for wall mounting on the
last page of this manual.
•
For information on locking the handset hook, refer to page 13.
Slide the wall
mounting adaptor
up to this point.
83 mm
(3-1/4 in)
100 mm
(3-15/16 in)
Washer
Drive the screw
to this point.
NT300M_QRG.fm Page 16 Tuesday, May 22, 2007 11:36 AM
