Panasonic KX-NS300, Руководство по установке

Страница: 237 / 300

Application LAN Side Port Number WAN Side Port Number
RTP (UDP) Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS300 uses.)
*1
Start/End RTP (UDP) Port No.
(Use port numbers that are in the
range of the RTP ports that the
KX-NS300 uses.)
*1
Make sure the RTP Start Port (UDP) and the RTP End Port (UDP) specified
for the router are in the range of the RTP ports that the KX-NS300 uses. For
the range of RTP port numbers that the KX-NS300 uses, refer to "Port
Numbers for Optional DSP Card" in "8.5 Port Security".
*1
*1 The port number for NTP that the KX-NS300 uses is fixed to 123.
*2 The port number ranges must be within the range of RTP/RTCP for NAT traversal (16000–18047).
IP address can be assigned to the KX-NS300’s optional DSP cards. The following example shows the port number ranges set for
each IP address:
Installing KX-NT500 series IP-PTs at a remote site with Built-in Media Relay
Gateway
You can install KX-NT500 series IP-PTs at the remote site directly or from the local site as follows.
1.
Register the IP-PT. For details, refer to "5.8.1 Registering IP Telephones".
2.
Programme the settings for the IP-PT.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-IPEXT8 .
c.
Move the mouse pointer over the V-IPEXT8 card (Virtual IP Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
e.
Click the Remote Place tab.
f.
Configure the items shown below.
•
Change the value to Remote (MRG) for Phone Location .
g.
Click OK .
3.
Unplug the AC adaptor of the IP-PT, and then plug it in again to reboot the IP-PT manually. The IP-PT will
download settings automatically.
Installing KX-UT series SIP phones at a remote site with Built-in Media Relay
Gateway
There are 2 methods to install KX-UT series SIP phones at a remote site:
•
Set up the phones at the main site using the KX-NS300, and then send them to the remote site.
•
Set up the phones without connecting them to the KX-NS300 at the main site, and then send them to the
remote site.
Setting up KX-UT series SIP phones at the main site, and then sending them to remote site
1.
Register the phone. For details, refer to "5.8.1 Registering IP Telephones".
2.
Programme the settings for the phone.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-UTEXT8 .
c.
Move the mouse pointer over the V-UTEXT8 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d.
Click Port Property .
e.
Click the Remote Place tab.
Installation Manual 237
5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway