Panasonic KX-NS1000, Руководство по программированию, Страница: 333 / 1182

Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
Payload Type
Specifies the payload type for DTMF tones using RFC2833. Programming this parameter is only necessary if
DTMF is set to Outband (RFC2833) .
Value Range
96–127
Maintenance Console Location
9.15 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Port Property
Feature Guide References
5.2.1 IP Proprietary Telephone (IP-PT)
Secondary Setting
The settings on this screen are for programming the Automatic Rerouting to Secondary PBX feature for use
among IP extensions in a networked environment. For details and conditions regarding the use of this feature,
refer to "4.2.3.2 Automatic Rerouting to Secondary PBX" in the Feature Guide.
Setting Secondary Ports
Follow the steps below to designate secondary ports for IP extensions.
1.
Specify the secondary ports.
a.
Access the port property screen of the site where the ports will be set as secondary ports.
b.
In Primary/Secondary , set the unused ports that will be used as secondary ports to "Secondary".
Note
Ports that have already been registered (A value other than the default of "00:00:00:00:00:00" is
set for
IP Phone Registration ID (MAC Address) on the Main tab) cannot be set to
"Secondary" here.
2.
Access the port property screen of the site where primary ports will be assigned secondary ports.
3.
Click Set Secondary . A dialogue box will appear.
4.
From the drop-down list, select a site where secondary ports will be assigned.
Note
The number displayed for Available ports indicates the maximum number of available ports at the
selected site that can be registered as secondary ports.
5.
Extensions’ primary ports and names are displayed on the left. Select the extensions for which to want to
register secondary ports, and then click the right arrow.
Note
Ports that are already assigned as secondary ports will not be displayed in this list.
6.
Click Execute . A message confirming the registration will be displayed.
7.
Repeat steps 2 – 6 for each site where you want to designate secondary ports.
PC Programming Manual 333
9.15 PBX Configuration—[1-1] Configuration—Slot—V-IPEXT32—Port Property