Connecting an AC Adaptor to an IP-CS
The units comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your
network, these units can receive the necessary power supply from the network through the network cable. In
this case, no AC adaptor is needed for the units.
However, if PoE is not available, you will need to connect an AC adaptor to the unit.
WARNING
When installing or testing a unit with an external AC adaptor, the AC adaptor should be plugged
into a wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the adaptor may cause it to become disconnected.
Note
Use only the optional AC adaptor KX-A239 for the unit.
1.
Connect the AC adaptor cord to the unit.
AC Adaptor Cord
2.
Pass the cord through the groove of the unit in one of the following three ways.
To AC Adaptor
2
To AC Adaptor
3
To AC Adaptor
1
1
3.
Connect the AC adaptor to an AC outlet.
Quick Installation Guide
11
3 Installing the IP-CSs
