Panasonic KX-NCP500GR, Руководство по обслуживанию

Страница: 7 / 159

7
KX-NCP500GR
3 Specifications
3.1. General Description
3.2. Characteristics
Control Bus Original bus (16 bit, 8 MHz,10 megabytes per second)
Communication Bus H.100 bus conformity (1024 time slot)
Switching Non-blocking
Power Input
100 V AC to 130 V AC; 1.0 A/200 V AC to 240 V AC; 0.6 A; 50Hz/60 Hz
Power Consumption (when fully mounted)
51 W (240 V: 122 VA, 200 V: 113 VA, 130 V: 100 VA, 100 V: 92 VA)
Maximum Power Failure Tolerance 300 ms
Memory Backup Duration 7 years
Dialling Trunk Dial Pulse (DP) 10 pps, 20 pps
Tone (DTMF) Dialling
Extension Dial Pulse (DP) 10 pps, 20 pps
Tone (DTMF) Dialling
Mode Conversion DP-DTMF, DTMF-DP
Ring Frequency 20 Hz/25 Hz (selectable)
Trunk Loop Limit 1600
Ω
maximum
Operating Environment Temperature 0
°
C to 40
°
C
Humidity 10%to 90%
Conference Call Trunk From 10 x 3-party conference call to 4 x 8-party conference call
Music on Hold (MOH) 1 port (Level Control: -6 dB to +6 dB per 3 dB)
MOH1: Selectable Internal/External Music Source port
Paging Internal Level Control: -6 dB to +3 dB per 3 dB
External 1 port (Volume Control: -15 dB to +6 dB per 3 dB)
Serial Interface Port RS-232C 1 (max 115.2 kbps)
RJ45 Port MNT Port 1 (for PC connection)
LAN Port 1 (for LAN connection)
Extension Connection Cable SLT 1 pair wire (T, R)
DPT 1-pair wire (D1, D2) or
2-pair wire (T, R, D1, D2)
APT 2-pair wire (T, R, D1, D2)
PT-interface CS 1-pair wire (D1, D2)
PT-interface CS (High-density) 4-pair wire (D1, D2)
DSS Consoles and Add-on Key Module 1-pair wire (D1, D2)
Dimension 430 mm (W) x 88 mm (H) x 340 mm (D)
(17 in x 3 1/2 in x 13 3/8 in)
Weight (when fully mounted) Under 7 kg (15.4 lb.)
Terminal Equipment Loop Limit • PT: KX-DT300/KX-T7600 series DPT: 90
Ω
; all other DPTs/APTs:40
Ω
• SLT: 600
Ω
including set
• Doorphone: 20
Ω
• CS: 65
Ω
Minimum Leakage Resistance 15000
Ω
maximum
Maximum Number of Extension
Instruments per Line 1 for PT or SLT
2 by Parallel or eXtra Device Port connection of an APT/DPT and an SLT
3 by Digital eXtra Device Port connection of 2 DPTs and an SLT
Ring Voltage 75 Vrms at 20 Hz/25 Hz depending on the Ringing Load
Trunk Loop Limit 1600
Ω
maximum
Hookswitch Flash/Recall Timing Range 24 ms to 2032 ms
BRI Cards Internal ISDN Mode Supply Voltage: 40 V
Power Supply (BRI2): 4.5 W per 1 line, 9 W per 2 lines
Power Supply Method: Phantom Power Supply
Door Opener Current Limit 24 V DC/30 V AC, 1 A maximum
External Relay Current Limit 24 V DC/30 V AC, 1 A maximum
External Sensor Current Limit Power to the external sensor is provided from the EIO4 card and must be grounded through
the EIO4 card. For the connection diagram, refer to EIO4 Card (KX-TDA0164). The PBX
detects input from the sensor when the signal is under 100
Ω
.
Paging Terminal Impedance 600
Ω
MOH (Music on Hold) Terminal Impedance 10000
Ω