Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Note:
R
For information about deregistering
devices, refer to the User’s Guide
(page 18).
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks slowly in green.
2
Sensor:
Press and hold
M
N
until the
LED indicator blinks slowly in
green (page 9).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
sensor, press
M
N
on the hub and
on the sensor again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the
[Home Network]
app, you can
assign a name to your devices and
group them by location. For more
information, refer to the User’s Guide
(page 18).
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
11
Setup
HNS104EX_(en_en)_0111_ver.305.pdf 11
2017/01/11 18:33:55
