Inserting the battery
R
USE ONLY a CR2 Lithium battery.
R
Confirm the polarities (
,
).
1
Remove the main unit cover.
R
Lift from the indented area (
A
)
and open the main unit cover
(
B
).
1
2
2
Insert the battery.
3
Attach the main unit cover.
Registering the
sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the sensor, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks in green.
2
Sensor:
Remove the main unit cover and
press and hold
M
N
until the
LED indicator blinks in green
(page 8).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
sensor, press
M
N
on the hub and
on the sensor again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the
[Home Network]
app, you can
assign a name to your devices and
For assistance, please visit www.panasonic.com/support
9
Setup
HNS103̲(en̲en)̲0203̲ver.062.pdf 9
2015/02/03 20:01:37
