Part names and
functions
n
Sensor unit
B
C
A
n
Magnet unit
D
Sensor unit cover
M
N
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
Magnet unit cover
LED indicator
You can press
M
N
and check the
LED indicator to confirm the sensor’s
status.
Indicator
Status
Green, lit
Window/door is closed
Red, lit
Window/door is open
Indicator
Status
Red,
blinking
Sensor is out of range
of the hub
Green,
blinking
Registration mode
(You pressed and held
M
N
)
Off
No battery power
Note:
R
The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 8).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The window/door sensor is battery
powered.
3
Registration
Required only if the window/door
sensor was purchased separately
(i.e., not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Temporary placement
Temporarily place the window/
door sensor in the desired location
and confirm that it operates
properly (page 10).
6
Installation
Install the window/door sensor on
the same position where proper
7
Setup
HNS101AZ_(en_en)_0325_ver.031.pdf 7
2015/03/25 14:20:39
