Panasonic KX-HNH100FX, Руководство по эксплуатации

Страница: 37 / 56

Deactivating remote operation
Press * in step 2 on “Remote access code”,
page 36.
R The entered remote access code is deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts, enter
your remote access code.
3 n Hungary and Poland:
Press 9 to start voice guidance and
follow the voice guidance prompts as
necessary, or control the unit using
remote commands (page 37).
R If you do not press any dial keys
within 10 seconds after a voice
guidance prompt, the unit
disconnects your call.
n Czech, Slovakia, and other
countries:
Control the unit using remote
commands (page 37).
4
When finished, hang up.
Remote commands
Press the following dial keys to access the
corresponding answering system functions:
Key Operation
1 Repeat message (during
playback)
*1
2 Skip message (during playback)
4 Play new messages
5 Play all messages
6 Play greeting message
7 Record greeting message
9 Stop recording or playback
Start voice guidance
*2
0 Turn answering system off
*4 Erase currently playing message
Key Operation
*5 Erase all messages
*6 Reset to a pre-recorded greeting
message (during greeting
message playback)
*# End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 Hungary and Poland only
Turning on the answering system
remotely
Important:
R The answering system must be activated
(page 33) in order to turn it on remotely.
1
Dial your phone number from a
touch-tone phone.
2 n
Hungary and Poland:
Let the phone ring 10 times.
n Czech, Slovakia, and other
countries:
Let the phone ring 9 times.
R A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your
remote access code again and begin
remote operation (page 36).
Answering system settings
Call screening
While a caller is leaving a message, you can
listen to the call through the handset’s speaker.
To adjust the speaker volume, press
MDN or
MCN repeatedly.
You can answer the call by pressing M N on
the handset.
Call screening can be set for each handset.
The default setting is
“
On
” .
37
Answering System