Panasonic HomeHawk KX-HNC800, Руководство пользователя

Страница: 93 / 156

Setting
[Silent Mode] [Protection Mode]
1st camera
2nd or later
camera
1st camera
2nd or later
camera
Camera Sound
[OFF] [OFF]
[Announcement
]
[OFF]
*1 Refer to “Sync”, Page 93 for more information.
Creating new modes
You can create new modes to operate your devices when an event occurs such as motion is detected.
1
Access the mode screen ( “Accessing the mode screen”, Page 92).
2
Tap .
3
Change the settings as required.
R Each setting is explained in this section.
4
When finished, tap [OK] .
Mode Name
When creating a new mode, you can set the name used for the mode. This helps you to identify the
mode from other modes used on your mobile device.
–
To enter a name: Tap the text field, enter the text, and then tap [OK] .
Recording
You can enable and disable recording, and also specify the recording duration for each camera.
–
To enable/disable recording: Slide the switch next to each camera name to the desired position.
– To select a recording duration: Tap the time displayed next to each camera name, specify the
desired duration, and then tap [OK] .
Sync
You can coordinate cameras so that when 1 camera detects motion, the other camera starts
pre-recording. (Images are temporarily stored, and if motion is detected later, images are then saved on
the access point’s SD card.)
–
To enable/disable camera coordination: Slide the [Sync] switch to the desired position.
Note:
R Sync is only available when 2 or more front door cameras or outdoor cameras are registered to the
access point.
[Push Notification]
Push notifications are displayed on your mobile device when motion is detected.
–
To enable/disable push notifications: Slide the switch next to each camera name to the desired
position.
Note:
R After recording has started for a camera, motion detection notifications from that camera are not sent
to mobile devices. However, motion detection notifications from other cameras are sent.
93
Using a front door camera and outdoor camera