Panasonic HomeHawk KX-HNC800, Руководство пользователя

Страница: 108 / 156

Setting up the HD camera
Before you begin
In this procedure, the camera will enter “temporary access point mode”. In this mode, you can use your
mobile device’s wireless network feature to connect directly to the camera, and then use your mobile
device to change the camera’s wireless settings so that the camera can connect to your wireless router.
Confirm the following before you begin.
– Make sure you have installed the
[HomeHawk] app on your mobile device
– Make sure the camera is located within range of your wireless router
– Make sure your mobile device is connected to your wireless router
– Make sure your mobile device can connect to the Internet
– Make sure you know the wireless network name (SSID) and password assigned to your wireless router
Initial setup for iPhone, iPad
Important:
R If other HD cameras are already registered to your mobile device and you want to set up another HD
camera, see “Adding another HD camera”, Page 133.
1
Plug in the camera and wait about 1 minute for the camera’s LED to light in green.
R If the LED does not light in green, or if you experience trouble during this procedure, use the
camera’s reset button to reset the camera ( “Using the camera’s reset button”, Page 132) and
then repeat this procedure.
2
Start the [HomeHawk] app.
R The end-user license agreement is displayed the first time you start the app.
3
Follow the on-screen instructions.
4
Tap [Indoor HD Camera] .
5
Tap [Set up the HD Camera] .
6
When prompted, press the SETUP button on the back of the camera, and then tap [Next] .
R The LED indicator blinks in green.
7
iOS 11.0 or later users:
Tap [Join] and then continue from step 9.
iOS 10.x users:
Change your mobile device’s wireless network setting temporarily so that it connects to the camera
directly.
R Open your mobile device’s [Settings] app, tap [Wi-Fi] , select “KX-HNC800_Panasonic”, enter
“00000000” as the password, and then tap [Join] .
R If more than one item named “KX-HNC800_Panasonic” is displayed, turn off the power for the
other cameras and only operate 1 camera at a time.
8
Start the [HomeHawk] app again.
9
If necessary, enter the password required to connect to your wireless router and then tap [Next] .
R The camera and your mobile device connect to your wireless router.
R If prompted, follow the on-screen instructions and connect your mobile device to your wireless
router, start the app again, and then tap
[Add This Mobile Device] .
R If you enter the wrong password, an error is displayed. Repeat the initial setup procedure from the
beginning.
10
When prompted, press the SETUP button on the back of the camera.
R The camera registers your mobile device.
11
When prompted, set the password that will be used to connect to the camera and then tap [Next] .
108
Using an HD camera