12
Installation
8. Installation
8.1 Installation environment
The equipment is not intended for continuous exposure to direct sunlight. This might accelerate the
aging process of the front panel film.
The equipment is not intended for installation in contact with corrosive chemical compounds. Check
the resistance of the front panel film to a specific compound before installation.
Do not use tools of any kind (screwdrivers, etc.) to operate the touch screen of the panel.
In order to meet the front panel degree of protection if the following requirements are met:
•
The borders of the cutout must be flat
•
Each fixing screw must be tightened until the plastic bezel corner get in contact with the panel.
•
The cutout for the panel must be of the dimensions indicated in this manual.
The IP66 is guaranteed only if:
•
The max. deviation from the plane surface to the cut-out is ≤0.5mm
•
The thickness of the case where the equipment is mounted is from 1.5mm to 6mm
•
The max. surface roughness where the gasket is applied is ≤120um.
8.2 Applying the gasket
The gasket should be applied on the rear of the frame.
HM504, HM507
HM510, HM513
A:
Gasket
B:
Installation cutout
