7
5 Location of Controls and Components
5.1. CONTROL PANEL
5.1.1.
Keys description
In each menu only activated keys are described. The keys NOT described are NOT activated.
Any key pressing is followed by a short sound.
The ON-OFF
key is prior to any other key. This key, even if is pushed together any other key, is accepted.
A counter is incremented every 1sec a key is held. In the case where a key has been held >= 25 sec continuously, the UI returns to
STAND-BY status; a single sound (0.5s) is emitted.
The key not lighted up are not accepted, and so no sound emission if pressed.
Pressing the
key for 3sec, the UI returns to STAND-BY status and a single sound is emitted for 0.5sec.
5.1.2.
First connection to the mains
The clock setting is done as follows:
Due to the statement above described (error after 25sec of continuously pressed key), a complete round of 24h while keeping
pressed the
keys, must be done in less than 25sec.
5.1.3.
Clock setting after first connection
The clock setting is done as follows:
on-off
function selection
temperature setting
duration timer
delay timer
descrease - minus
increase - plus
minute minder
clock set
PROCEDURE
DISPLAY SHOWS
KEYS USE
Power ON
D1 shows “00:00” NOT flashing
keys
flash
Increase/decrease time, with higher speed is keep pressed
Waiting 3sec the time is fixed and D1 is fixed with the two central
dots flashing with frequency 1Hz. The display is set to CLOCK status
(see below §
4 for status descriptions). Until keys
are n ot
pressed, display remains in this status
PROCEDURE
DISPLAY SHOWS
KEYS USE
CLOCK status
D1 shows the clock
icon
flashes
Press for 3 seconds, D1 show the clock flashing
CLOCK setting D1 shows the clock flashing
Increase/decrease time, with higher speed is keep pressed
Waiting 3sec the time is fixed and D1 is fixed with the two central
dots flashing with frequency 1Hz.