- 217 -
3
Press the recording start/stop button.
(When [Party Scene]/[Moving Object] is selected)
≥
Before recording starts, the Remote Pan Tilt Cradle rotates and returns to its home position. It
takes time until recording starts.
≥
The Remote Pan Tilt Cradle operates within the range set in advance.
(When [Manual]/[Preset Positions] is selected)
≥
Performing the operation of Step 2 during recording may cause the recording screen to shake or
the Remote Pan Tilt Cradle to move from its original location.
To switch the Remote Pan Tilt Cradle Mode
Touch
.
≥
The selection screen of the Remote Pan Tilt Cradle Mode is displayed. Touch the desired mode.
To exit the Remote Pan Tilt Cradle
Touch [EXIT].
≥
The Remote Pan Tilt Cradle rotates and returns to its home position.
≥
After the operation, the Remote Pan Tilt Cradle turns off. Before removing this unit, disconnect
the USB cable.
∫
Registering positions to the position buttons
1
Touch
.
2
Touch the position button to which you want to register a position.
≥
You can register positions to [POS1]/[POS2]/[POS3]/[POS4]/[POS5]
≥
The position buttons without a registered position are indicated as [Not set].
3
Determine a position with
/
/
/
≥
You can also operate the zoom with the zoom lever.
4
Touch [ENTER].
≥
To register positions to other position buttons, repeat Steps 2–4.
≥
To adjust a position that has already been registered to a position button, touch the position
button to which the position you want to adjust is registered, and follow Steps 3–4.
∫
Moving the Remote Pan Tilt Cradle to a registered position
1
Touch
.
≥
Check that
is highlighted in yellow.
≥
The position buttons ([POS1]/[POS2]/[POS3]/[POS4]/[POS5]/[HOME]) will be displayed.
These buttons will disappear when no touch operation is performed for approximately 5 seconds.
To display them again, touch the screen.
2
Touch the desired position button.
≥
The Remote Pan Tilt Cradle will move to the registered position of the selected position button.
≥
You cannot select position buttons without a registered position.
≥
If you touch [CANCEL], the Remote Pan Tilt Cradle will stop in a midway position.
≥
To return to the home position, touch [HOME].
∫
Using Cycle Mode
In this mode, the Remote Pan Tilt Cradle cycles through positions registered to the position buttons
in the desired sequence.
The default sequence is as follows: [HOME]
#
[POS1]
#
[POS2]
#
[POS3]
#
[POS4]
#
[POS5]
Setting up [Preset Positions]
P O S
P O S