![background image](http://html1.mh-extra.com/html/panasonic/gpus932cu-3ccd-color-camera-ccu/gpus932cu-3ccd-color-camera-ccu_operating-instructions-manual_3738836006.webp)
6
Precautions
Do not attempt to disassemble this product.
To prevent electric shock, do not remove screws or covers.
There are no user-serviceable parts inside.
Ask a qualified service person for servicing.
Handle this product with care.
Do not abuse the product. Avoid striking, shaking, etc. The
product could be damaged by improper handling or stor-
age.
Cleaning this product body
Turn the power off when cleaning the product. Use a dry
cloth to clean the product.
Do not use strong abrasive detergent when cleaning the
product. When the dirt is hard to remove, use a mild deter-
gent and wipe gently. Then, wipe off the remaining deter-
gent with a dry cloth.
Otherwise, it may cause discoloration. When using a chemi-
cal cloth for cleaning, read the caution provided with the
chemical cloth product.
Do not expose this product to rain or moisture, or try to
operate it in wet areas.
Turn the power off immediately and ask a qualified service
person for servicing. Moisture can damage the product,
and also create the danger of electric shock.
Use this product for indoor use only.
Do not expose the product to direct sunlight for hours and
do not install the product near a heater or an air condition-
er. Otherwise, it may cause deformation, discoloration and
malfunction. Keep the product away from water.
Do not drop anything inside this product.
Dropping a metal part or other materials inside the product
could permanently damage the product.
Do not operate this product beyond the specified tem-
perature, humidity, or power source ratings.
Use the product under conditions where temperature is
between 0°C and +40°C {32°F and 104°F}, and humidity is
below 90 %. The input power resource is 12 V DC.
Clean the faceplate with care.
Do not clean the faceplate with strong or abrasive deter-
gents. Use lens tissue or a cotton tipped applicator and
ethanol.
Discoloration on the CCD color filter
When continuously shooting a bright light source such as a
spotlight, the color filter of the CCD may have deteriorated
and it may cause discoloration. Even when changing the
fixed shooting direction after continuously shooting a spot-
light for a certain period, the discoloration may remain.
Do not aim the camera head at strong light sources.
A light source such as a spot light causes a blooming (light
bleeding) or a smear (vertical lines).
Installing place
Contact your dealer for assistance if you are unsure of an
appropriate place in your particular environment.
Make sure that the installation area is strong enough to hold
the product, such as a concrete ceiling. When the installa-
tion area is not strong enough, reinforce and strengthen it.
Avoid installing in the following locations.
• Locations where it may get wet from rain or water
splash
• Locations where a chemical agent is used such as a
swimming pool (not only outdoor)
• Locations subject to steam and oil smoke such as a
kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emissions are pro-
duced
• Locations subject to strong magnetic field or radio
waves
• Locations where corrosive gas is produced
• Locations where it may be damaged by briny air such
as seashores
• Locations where the temperature is not between 0°C
and +40°C {32°F and 104°F}.
• Locations subject to vibrations (the product is not
designed for on-vehicle use.)
• Locations subject to condensation as the result of
severe changes in temperature
Smear
Bright subject
Blooming
Содержание GPUS932CU - 3CCD COLOR CAMERA CCU
Страница 31: ...31 ...