26
These things are normal:
The oven causes
Some radio and TV interference might occur when you cook
interference with
with the microwave oven. This interference is similar to the
my TV.
interference caused by small appliances such as mixers,
vacuums, blow dryers, etc. It does not indicate a problem with
your oven.
Steam accumulates
During cooking, steam and warm air are given off from the
on the oven door and
food. Most of the steam and warm air are removed from the
warm air comes from
oven by the air which circulates in the oven cavity. However,
the oven vents.
some steam will condense on cooler surfaces such as the
oven door. This is normal. After use, the oven should be
wiped dry (see page 25).
The oven is not plugged in
Remove plug from outlet, wait
securely.
10 seconds and re-insert.
Circuit breaker or fuse is
Reset circuit breaker or replace
tripped or blown.
fuse.
There is a problem with the Plug another appliance into the
outlet.
outlet to check if it is working.
The door is not closed
Close the oven door securely.
completely.
Start
Pad was not pressed Press
Start
Pad.
after programming.
Another program is already Press
Stop/Reset
Pad to cancel
entered into the oven.
the previous program and enter
new program.
The program is not correct. Program again according to the
Operating Instructions.
Stop/Reset
Pad has been
Program oven again.
pressed accidentally.
The Glass Tray is not
Take out Glass Tray and Roller
positioned properly on the
Ring. Wipe with a damp cloth and
Roller Ring or there is food
reset Roller Ring and Glass Tray
under the Roller Ring.
properly.
The Roller Ring and oven
Clean these parts according to
bottom are dirty.
Care and Cleaning of your
Microwave Oven
(see page 25).
The CHILD LOCK was
Deactivate LOCK by pressing
activated.
Stop/Reset
pad 3 times.
Oven will not turn on.
Oven will not start
cooking.
The Glass Tray
wobbles.
When the oven is
operating, there is
noise coming from
the glass tray.
The word “LOCK”
appears in the
Display Window
.
PROBLEM
POSSIBLE CAUSE
REMEDY
Before Requesting Service
This displaying indicates a
problem with the microwave
generation system.
Please contact an authorised
Service Center (see page 27).
The oven stops cooking
by microwave and "H97"
or "H98" appears in the
display window.
IP1069_38N00AP_08_070510 2007.5.10 09:41 Page 28