Panasonic EY4541X57, Руководство по эксплуатации

Страница: 16 / 148

- 16 -
Cutting circles
1. If cutting away a section, make a
drill hole on workpiece to let the
jigsaw blade pass through.
2. Align the pin hole of the rip fence
with the center of the circle, and
then use a nail or screw to hold the
object in place.
3. Without touching the workpiece,
turn on the power switch.
4. Cut along the marked line.
Control Panel
(1)
(3)
(2)
(1) LED light
Before the use of LED
light, always pull the
power switch once.
Press
the LED
light button.
The light illuminates
with very low current,
and it does not ad-
versely affect the
performance of the
driver during use or
its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tem-
porarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified
herein may result in hazardous radiation ex-
posure.
(2) Overheat warning lamp
To protect the motor or battery, be
sure to note the following when car-
rying out this operation.
• If the motor or battery becomes hot, the
protection function will be activated and
the motor or battery will stop operating.
The overheat warning lamp on the
control panel illuminates or flashes
when this feature is active.
• If the overheating protection feature
activates, allow the tool to cool tho-
roughly (at least 30 minutes). The tool
is ready for use when the overheat
warning lamp goes out.
• Avoid using the tool in a way that
causes the overheating protection fea-
ture to activate repeatedly.
• If the tool is operated continuously under
high-load conditions or if it is used in
hot-temperature conditions (such as
during summer), the overheating protec-
tion feature may activate frequently.
Off
(normal
operation) Flashing: Overheat
Indicates operation has
been halted due to
battery overheating.