Selecting the input signal
ENGLISH - 11
Selecting the input signal
The method to switch the input of the image to project is as follows.
f
Press the input selection button on the remote control or the control panel of the projector and directly specify
the input of the image to project.
f
Display the input selection screen and select the input of the image to project from the list.
Switching the input directly
The input of the image to project can be switched by directly specifying it with the input selection button on the
remote control or the control panel of the projector.
1) Press the <SLOT 1> button, <SLOT 2> button, or <SLOT> button.
<SLOT 1>
*1
Switches to the input of this Interface Board installed in <SLOT 1>.
The input is switched every time the button is pressed when one of the inputs is selected on the
installed Interface Board.
<SLOT 2>
*1
Switches to the input of this Interface Board installed in <SLOT 2>.
The input is switched every time the button is pressed when one of the inputs is selected on the
installed Interface Board.
<SLOT>
*2
Switches to the input of this Interface Board installed in <SLOT>.
The input is switched every time the button is pressed when one of the inputs is selected on the
installed Interface Board.
*1 For the projector equipped with two slots
*2 For the projector equipped with only one slot
Note
f
If the SFP module for receiving or for sending and receiving is not installed in the SFP port, the input will be treated as the status that there
is no input signal.
f
The operation when the <SLOT 1> button, <SLOT 2> button, or <SLOT> button is pressed can be fixed to the operation to switch to the
specified input using the [SECURITY] menu
→
[CONTROL DEVICE SETUP],
Switching the input by displaying the input selection screen
The input of the image to project can be selected by displaying the input selection screen.
1) Press the <INPUT MENU> button on the remote control or the control panel of the projector.
f
The input selection screen is displayed.
Following input selection screen is an example when the Interface Boards are installed in <SLOT 1> and
<SLOT 2> of PT-RQ22K.
INPUT SELECT
SDI1
SDI2
SDI3
SDI4
DIGITAL LINK
SDI OPT1 [SLOT1]
SDI OPT2 [SLOT1]
SDI OPT1 [SLOT2]
SDI OPT2 [SLOT2]
SELECT
SET
ENTER
2) Press the <INPUT MENU> button again.
f
The input will switch each time you press the <INPUT MENU> button.
Note
f
Input can be switched by pressing
as
to select the input of the image for projection and pressing the <ENTER> button while the input
selection screen is displayed.
f
If the SFP module for receiving or for sending and receiving is not installed in the SFP port, the input will be treated as the status that there
is no input signal.
