Installing the interface board
ENGLISH - 5
Restrictions on interface board attachment slots
The Multi Window Processor has 16 slots to connect input and output interface boards, with the following slot restrictions:
f
Slot1
and
Slot2
are only for input interface boards. Output interface boards cannot be installed.
f
Slot15
and
Slot16
are only for output interface boards. Input interface boards cannot be installed.
f
Install input interface boards in ascending order starting at
Slot1
without leaving any slots empty. To use the Multi Window Processor, you
will need to attach at least one input interface board to
Slot1
.
f
Install output interface boards in descending order starting at
Slot16
without leaving any slots empty. To use the Multi Window Processor,
you will need to attach at least one output interface board to
Slot16
.
f
An empty slot can only be set to remaining slots between an attached slot on an input interface board and an attached slot on an output
interface board.
f
Make sure to attach a slot cover to empty slots.
Slot1
Slot5
Slot9
Slot13
Slot2
Slot6
Slot10
Slot14
Slot3
Slot7
Slot11
Slot15
Slot4
Slot8
Slot12
Slot16
Only for input
Only for output
Slot order for installing the input interface boards
Slot order for installing the output interface board
Installing the interface board
Screws
Screws
Fig. 1
Fig. 2
Fig. 3
1) Remove the slot cover. (Fig. 1)
f
Use a Phillips-head screwdriver to turn the two screws with toothed lock washers securing the slot cover counterclockwise and
remove. The removed screws with toothed lock washers will be used to secure the interface board.
f
If the slot cover is difficult to remove, insert the tip of a straight slot screwdriver between the right and left edges of the slot cover and
the rear surface of the device to remove.
2) Install the interface board to the Multi Window Processor. (Fig. 2)
f
Insert the interface board along the grooves of the empty slot, press the bracket, and push the board in until fully and securely
inserted.
3) Secure the interface board. (Fig. 3)
f
Tighten to secure with the two screws with toothed lock washers removed in Step
1)
.
Attention
f
The removed slot cover will be required when removing an interface board that is no longer needed. Store it for installation at a later date.
