Panasonic ET-JPF100BU, Руководство по эксплуатации

Страница: 7 / 16

ENGLISH - 7
Mounting procedure
Main procedures
The main procedures up until installation of the projector are as follows.
For details on 1) to 3), refer to the corresponding reference pages.
1) Changing the orientation of the main unit of the projector (

7 page)
2) Mounting the floor stand to the projector (

8 page)
3) Connecting the power cord to the projector (

10 page)
4) Installation
z
Install the projector while referring to “Projection related dimensions” in the operating instructions for the
projector. Then adjust the orientation of the main unit as described in “Adjusting the projection position.”
z
If necessary, refer to “Attaching a security wire” (

12 page) in this manual and take a measure to protect
the equipment against theft.
Changing the orientation of the main unit of the projector
This section describes changing the orientation of the main unit of the projector to make the mounting work easier
to do.
Rotating fixing
screw
1) Place the projector on a cloth or the like that
has been laid on a flat surface.
2) Loosen the fixing screw.
z
Loosen the rotating fixing screw of the projector
with the 7/64” Allen wrench supplied with the
projector.
Shaft holder
Main unit
3) Change the orientation of the main unit.
z
Loosening the rotating fixing screw enables
rotation of the shaft holder so that the
orientation of the main unit can be changed.
4) Tighten the fixing screw.
z
Tighten the rotating fixing screw with the
7/64” Allen wrench supplied with the projector
to prevent the main unit moving during the
mounting work.
Note
z
The rotating fixing screw is a hexagon socket head
screw (M6). Take care because it will come out of
the projector if loosened too much.