Panasonic ET-D3LEU100, Руководство по эксплуатации

Страница: 7 / 24

ENGLISH-7
Preparation (continued)
Lens calibration
Perform lens calibration after attaching the lens.
The lens calibration procedure differs depending on the projector you are using and the
main version of the firmware.
z
PT-RQ32K / PT-RZ31K / PT-RS30K / PT-RQ22K / PT-RZ21K / PT-RS20K
Refer to "Case 1" (
x
page 7).
z
PT-RQ13K / PT-RZ12K / PT-RS11K / PT-DZ21K2 / PT-DS20K2 / PT-DW17K2 /
PT-DZ16K2 / PT-DZ13K / PT-DS12K / PT-DW11K / PT-DZ10K
Refer to "Case 2" (
x
page 9).
■ Case 1
z
PT-RQ32K (main version of the firmware is 3.16 or later)
z
PT-RZ31K / PT-RS30K (main version of the firmware is 3.09 or later)
z
PT-RQ22K (main version of the firmware is 1.05 or later)
z
PT-RZ21K / PT-RS20K (main version of the firmware is 2.07 or later)
The illustrations in this procedure depict
use of the ET-D3LEW200 as an example.
1) Press the <MENU> button.
2)
Use the ▲ and ▼ buttons to
select [PROJECTOR SETUP],
and press the <ENTER>
button.
z
The [PROJECTOR SETUP] screen
appears.
3) Use the ▲ and ▼ buttons to
select [LENS], and press the
<ENTER> button.
z
The [LENS] screen appears.
4) Use the ▲ and ▼ buttons to
select [LENS CALIBRATION],
and press the <ENTER>
button.
z
The [LENS CALIBRATION] screen
appears.
z
When the ET-D3LEU100 is attached,
a confirmation screen appears when
the <ENTER> button is pressed. In
such cases, proceed to step 6.
1/2 PROJECTOR SETUP
PROJECTOR ID ALL
PROJECTION METHOD
LENS
OPERATION SETTING NORMAL
LIGHT OUTPUT 100.0%
BRIGHTNESS CONTROL AUTO
STANDBY MODE NORMAL
NO SIGNAL SHUT-OFF DISABLE
NO SIGNAL LIGHTS-OUT DISABLE
INITIAL STARTUP
LAST MEMORY
STARTUP INPUT SELECT
LAST USED
DATE AND TIME
SUB MENU
MENU SELECT
ENTER
SUB MENU
MENU SELECT
ENTER
LENS
LENS TYPE ET-D3LEW200
LENS INFORMATION SETTING
LENS MEMORY
LENS HOME POSITION
ACTIVE FOCUS OPTIMIZER
LENS CALIBRATION