Amplitude is too
small.
<CHECK DRIVING HEAD AMPLITUDE.>
NO Replace linear
motor.
Does not sharp
enough.
Turn the switch ON, and measure the amplitude
using a pin of
(only the case
the
drivin head. (See the figure as shown above.)
amplitude is
clear-
ance (2.8mm
full
wideth.))
NO
Replace module.
Does not function, but
<CHECK MODULE.>
NO Replace module.
LED flashes.
Take out the right battery. (Viewed from the front.)
Connect lead
NO
wire with chassis and (-) terminal of battery. Check
charging current
Replace linear
motor.
between lead wire comes from module side (stated
on WIRING CON-
NECTION DIAGRAM) and (+) terminal of battery
setting on the normal
adaptor. Okay if it is more than 600mA when
connecting to rated
voltage.
NOTE: The charging current fluctuates depending on the space between charging adaptor and
the coil. / Please follow the procedure below.
1. Put the coil and the bottom part of housing close together.
2. Put the bottom part of housing and the charging adaptor close
together.
3. Measure the charging currents between (+) terminal of battery and
lead wire comes from module side.
8
