background image

57

56

Additional Information

How to Get the Most Out of Your Massage Lounger
(1) Start with a rolling massage only to allow your body to get used to the massage lounger.  This

stretches out your spine and relieves pressure from your cervical disks.

(2) Next use a kneading or tapping massage in areas surrounding stiff muscles.
(3) To finish off with use a rolling massage again to stretch your spine again.

Example of 
a Localized Massage

Adjusting Massage Strength

• For safety reasons there are areas where it is not

possible to select a massage strength of 5.

is pressed when massage strength has been set to

4 or 5, massage strength will automatically be set to 3 or
4 depending on the type of massage before lateral
massage is carried out.  

• When using Roll independently or in combination with

other kinds of massage, the maximum massage
strength setting is 3.

Rolling Massage

• When a massage is being carried out over a wide area,

if Roll is selected, then the width of the massage will
automatically be reduced before the Roll massage
begins.  

Upper Body Massage Adjustment

The scope of the massage rollers depending on the type of massage selected is shown below.

Shoulder grasp massage

Neck and Shoulders

Back

Lower Back

Use Knead B on the neck and
Knead A, Shoulder grasp and

Shiatsu A on the shoulders.

Use Swedish, Knead C and

Soft Shiatsu up and down 

the back.

Use Swedish and 

Shiatsu B from the bottom to

the top.

Approx. 15cm

Approx. 15cm

Approx. 21cm

Approx. 5cm

Points where massage
can be carried out at
the maximum strength
of 5.

Points where rolling
massage can be carried
out up and down the
back.

Points where massage
can only be carried out
at a maximum strength
of 4.

When the strength of the
massage has reached 4
you will hear a “beep-
beep-beep” sound.  

Approx. 15cm

Approx. 15cm

Approx. 15cm

Approx. 15cm

Approx. 15cm

Approx. 21cm

Approx. 21cm

Approx. 21cm

Approx. 76cm

Approx. 5cm

Approx. 30cm

Approx. 21cm

Approx. 5cm

Approx. 5cm

Approx. 15cm

Approx. 5cm

Rolling Massage

Other Massage

Approx. 15cm

Approx. 15cm

Approx. 21cm

Approx. 5cm

(1) The massage rollers move to the

shoulder position.

(2) The shoulders are pressed from

directly above by the upper rollers.

(3) The air unit provides a Shiatsu

massage from behind.

Please try the following if you want a stronger shoulder-grasping massage.

1. Remove your sweater or jacket if you are wearing one.
2. Lower the shoulder position slightly.
3. Lower the backrest.
4. Push your shoulders further back while moving them from side to side when setting the shoulder position or during the massage. 
5. If the massage is still not strong enough then remove the pillow and the back cushion. 

4. When you want to customize your massage even more.  

You can adjust the height and lateral movement of the massage heads, as well as the speed and strength
of the massage.  

5. After the massage has been completed the unit will automatically stop.

• The unit will automatically stop approximately 15 minutes after the massage begins.
• If you want to continue using the massage lounger then we recommend that you wait at least 10 minutes in between each massage.
• If you want to stop the massage during a program press 

.  Press 

if you want to stop the massage immediately.

Adjusting Massage Position

Press .

• Press the button as many times as you like in any direction to move the massage

heads to the position you require.

• Each time you press the button the massage heads move approximately 1.8 cm up or

down and approximately 0.6 cm left or right.  

• If you hold the up or down button down the massage heads will continue to move until

you release the button.

• When the massage heads have been moved as far as possible you will hear a "beep-

beep-beep" sound.  

• In some places the strength of the massage will be automatically reduced. 
• The approximate position of the massage will be shown on the display.
• In some cases the massage action will not immediately change even though the

massage action button is pressed.

Adjusting Massage Speed

Press .

• You can press the button as many times as you like to increase or decrease the speed

of the massage.  

• When the speed of the massage has been increased or decreased as much as

possible you will hear a “beep-beep-beep” sound.  

• It is not possible to adjust Shoulder grasp.
• The speed of the massage is shown on the Massage Action Display in five stages.  

Adjusting Massage Strength

Press .

• You can press the button as many times as you like to increase or decrease the

strength of the massage.  

• When the strength of the massage has been increased or decreased as much as

possible you will hear a “beep-beep-beep” sound.  

• In some places the strength of the massage will not be able to reach the maximum

level of 5.  

• The strength of the massage is shown on the Massage Action Display in five stages.  
• Shoulder grasp can be adjusted in five stages. 
• In some cases the massage action will not immediately change even though the

massage action button is pressed.

Adjusting Lateral Movement

Press .

• Press this button to increase the width of the massage in the location the 

massage heads were in when you pressed the button.  

will be shown on the display.

• In some places the strength of the massage will be automatically reduced. 
• Press the button again to revert to normal massage action.

Massage Actions (Upper Body)

Shiatsu: This feels as though the thumbs of both hands are being
used to work on the acupressure points.  The initial strong push is
followed by a short pause to give the impression of a professional
shiatsu massage therapist.  

3-Stage Shiatsu: This massage features three increasingly strong
pushes. 

Pressing: This massage presses stiff muscles toward the outside
and is effective on areas around the shoulder blades on the outer
shoulders as well as the lower back.  

Kneading: With this massage, a strong push is followed by a quick
release in a rhythm that is designed to relax stiff muscles.  It is ideal
for loosening stiff muscles in the neck and beside the spine.

Deep Kneading: With this massage the massage heads work slowly
over the acupressure points in a deep kneading motion.

Wide Kneading: This motion is like the palms of both hands being
used to press and rub over a wide area from both sides of the body.
This type of massage is ideal for someone wanting a broad swedish
style massage on the back or lower back.

Tapping: This motion is like a fist used in a rhythmic pattern to
provide a solid tapping that is designed to eliminate stubborn
stiffness and tiredness.  

Soft Tapping: With this massage soft tapping is carried out in a
rhythmic pattern alternately to the left and right.

Rhythmic Tapping: With this massage slow tapping is alternated
with light tapping to relax stiff muscles.

Rolling: The massage heads become rollers that roll over the back
up and down from the neck to the lower back to stretch the back
muscles and relieve tension.  

Regional Rolling: The massage heads become rollers that roll over
the back muscles, but this time in a specified 10 cm location.  

Pressing: With this massage the shoulder muscles are pressed down
from directly above to bring relief to stiff muscles.

Vibration: The high frequency vibration action helps your tense body
to relax.  This is ideal when used together with rolling, etc. for a full
body massage. 

Содержание EP3205


















Отзывы: