Panasonic EP1022-U1, Руководство по обслуживанию

Страница: 25 / 49

11 Cord arrangement of the connecting cord for power
supply and the connecting cord for controller.
*The two types of wires are to be arranged with the massage block set in its upper most position (in respect to the chair).
1. Connect the two connectors, (a) and (b) to Main PCB.
2. Install the ground wires (c).
3. Fix the Cord wire for chair side on the Back frame.
4. Grasp white mark on the Connecting cord for power supply by the Fitting B, and then fix them on the Back frame.
5. Bind two cords with two lead wires of massage clutch and up/down sensor by using a small cable tie.
6. Bind two cords on the hole of the Guide plate for gear box by using a small cable tie.
7. Set two cords to the Cord wire D and install and fix them on the Main frame.
8. Grasp white mark on the Connecting cord for power supply by the Fitting B, and then fix them on the Main frame.
9. Put the edge of the Cord wire D on two cords and bind them together by using a small cable tie.
10. Bind two cords with the Back frame by using a large cable tie.
11. Wind two cords around the Cord wire for chair side one and half times and bind them together using a small cable tie.
12. Bind two cords with a small cable tie on approx. 8 in. from above binding position.
*Caution during installation.
*Put the massage block at its upper most point.
*Do not allow the cord to ride on top of the frame.
25
EP1022-U1