Panasonic EP-MAC8, Руководство по эксплуатации

Страница: 73 / 80

EN35
Troubleshooting
Problem Cause and remedy
The massage heads stop
during use
(The unit beeps and all icons and
buttons on the remote controller
flicker and then go out.)
For safety, the massage heads will possibly stop upon a
too larger external force during use.
If all marks and buttons on the remote controller begin to flicker, it
suggests an extreme abnormality. In this case, turn off the power
switch and turn it on about 10 seconds later.
If the massage heads stop again, adjust your sitting posture and
do not lean on the backrest completely. (Users, particularly those
heavier than 100 k
g
, should follow relevant precautions.)
After a fault happens, inspect and try the corresponding method below.
If the fault still exists after that, contact the authorized service center from which you bought the unit.
The massage heads cannot
reach the shoulders or the neck
If the head is not in contact with the comfort cushion, or the back is not in contact
with the backrest, the shoulder position in body type detection will possibly be
lower than the actual position. Sit in the deepest position of the unit, lean your
head on the comfort cushion and operate from the beginning again. (EN20)
The left and right massage heads
have different heights (intensities)
An alternating tapping method is employed, which means that this phenomenon
will naturally occur. There is nothing wrong with the unit. （ EN33 ）
The unit cannot run at all
z
Upper body (the neck to the
lower back) massage
z
Leg/foot massage
z
The power cord is disconnected. (EN14)
z
The power switch is not turned on.
z
No program is selected after on the remote controller is
pressed.
The unit is damaged
The power cord or the power plug
has abnormal heating
To avoid accidents, contact an authorized service center.
The unit cannot tilt, or the leg/foot massage
section cannot be raised or lowered
(The unit beeps, the running light
on the remote controller go out and
the unit stops)
For safety, the unit will stop upon an obstruction or a too
large force.
If all contents and buttons are flickering and the backrest or the leg/
foot massage section has stopped, turn off the power supply and turn
it on about 10 seconds later and then operate the unit.
The power supply cannot be
connected even if is
pressed again after the massage
z
The program will terminate about 5 seconds after the massage
has ended. Press
mat least 5 seconds after all the
movements have stopped.
The heater does not heat even if the
function is enabled
If neither upper body massage nor leg/foot massage section is
enabled, the function will not work separately. (EN29)
The unit cannot cool down
even if the "DOUBLE
HEAT" function is disabled
z
Due to the heater structure, the unit will still feel warm shortly
after heating because of the residual heat.
z
If a single part is continually massaged even after the
function is disabled, you will feel increasingly warmer.
Neither the massage heads
nor the foot massage
section provides a warm
feeling
z
button is set to "off".
z
"SOLE HEAT" only fabrics in the tiptoe positions are warm. The warm
feeling depends on factors such as body type, massage method,
clothes and room temperature. When the foot massage section is
being raised, the warm transfer part is in close contact with the soles
to make you feel warm. You may cover your knees with a blanket to get
warmer.
Q
&
A /
T
rou
ble
sh
oo
tin
g