EN25
Elbow Component Dismantling Method
If it is required to move the body due to housing moving and
it cannot pass through the door, please dismantle the left-side
elbow component.
1
Remove the clamp screw
(1 piece each for front and rear)
Screw Removing Method
Allen Key
•
Secure the clamp screw on the edge
of Allen Key and align it with the hole
horizontally and then release.
•
If inserting the screw into the screw
hole improperly, then it may damage
the screw when fastening the screw
with Allen Key.
•
Pull the upper section of elbow component upward and then
dismantle it.
2
Remove the elbow component from the body.
CLEANING AND MAINTENANCE
Never use chemicals such as thinner, benzine,
alcohol, etc.
thinner
benzine
alcohol
Synthetic Leather, Plastic Area
Routine cleaning and maintenance
Wipe off dust and mild dirt with a soft dry cloth.
When dirty
1 Soak a soft cloth in water or
a mild detergent diluted to
3 – 5% with warm water,
and wring out thoroughly.
mild
detergent
2 Wipe the surface.
(Wipe the fabric parts
and synthetic leather
with a patting motion.)
Water
3 Wipe off the cleaning fluid with
a cloth moistened with water
only and thoroughly wrung out.
4 Wipe with a dry, soft cloth.
5 Allow the unit to dry naturally.
(Do not rapidly dry using dryers, etc.)
When the dirt is not easily removed
Try the following methods during Step 1.
<For synthetic leather>
Wipe with commercially available "melamine foam sponge"
soaking mild detergent.
English