Installation Manual
54
Operating Instructions
Confirming the elite Panaboard Operation
After assembling the elite Panaboard, confirm that it operates properly by following the procedure below.
Confirming the Interactive Features
1.
Following the procedure in “Installing the elite Panaboard software/book” (page 22), install the
software and connect the included USB cable.
2.
Confirm that the interactive features are operating correctly.
•
If a projector is not available, confirm operation using only the elite Panaboard and computer.
•
When the elite Panaboard software starts, the calibration screen is displayed on the computer screen.
•
Perform tentative calibration by touching each of the following points on the elite Panaboard with your
finger for about 2 seconds, one point after another. For precise adjustment, it is necessary to use a
projector.
•
Confirm operation by writing on the screen board with the electronic pen and checking that the writing is
displayed on the computer’s screen. (Your writing with the electronic pen will not appear on the screen
board itself.)
Action
Checkpoints
Operation
Measure
1
Turn on the power. Power LED (green) lights.
(Normal operation)
Power LED (green) does not
light, or Error LED (red) is
blinking.
Check the power cord.
See step 1 of “Assembling the elite Panaboard”.
•
•
For Mounting on a Stand KX-B061 (Sold
Separately)
1
3
4
2
Approx. 100 mm (3
7
/
8
in.)
Approx. 100 mm (3
7
/
8
in.)
UB-T880-PJQXC0337ZA_mst.book 54 ページ ２０１０年５月１１日 火曜日 午後１時９分
