- 31 -
Reference
∫
Dynamic Range Compression
You can listen at low volumes but still hear dialog
clearly.
(Dolby Digital, Dolby Digital Plus and Dolby
TrueHD only)
≥
“Auto” is effective only when playing Dolby
TrueHD.
∫
Digital Audio Output
Press [OK] to show the following settings:
h
Dolby Audio
h
DTS/DTS-HD
Select the audio signal to output.
≥
Select “PCM”, when the connected equipment
cannot decode the respective audio format.
This unit decodes the audio format and
transmits to the connected equipment.
≥
If you do not make proper settings the audio
may be static or noisy.
≥
If you set “Voice Guidance Setting” to “On”,
these settings will be fixed to “PCM”.
h
BD-Video Secondary Audio
Select whether or not to mix the primary and
secondary audio (including the button click
sound).
If “Off” is selected, the unit outputs the primary
audio only.
≥
To enjoy BD-Video that supports Dolby Atmos
®
or
DTS:X
TM
Connect this unit to an AV amplifier or similar device that
supports it with an HDMI cable, and select the following
settings:
– Dolby Audio: “Bitstream”
– DTS/DTS-HD: “Bitstream”
– BD-Video Secondary Audio: “Off”
Dolby Atmos is a trademark of Dolby Laboratories.
∫
OPTICAL Down Sampling
Set the maximum sampling frequency to be used
when outputting down-sampled audio from the
OPTICAL terminal.
≥
Set a frequency supported by the connected
device.
≥
When playing back BD-Video, signals are
converted to 48 kHz despite the settings in the
following cases:
– when the signals have a sampling frequency
of 192 kHz
– when the disc has copy protection
– when “BD-Video Secondary Audio” is set to
“On”
∫
Downmix
Select the downmix system of multi-channel to
2-channel sound.
≥
Select “Surround encoded”, when the
connected equipment supports the virtual
surround function.
≥
The downmix effect is not available when
“Digital Audio Output” is set to “Bitstream”.
≥
The audio will be output in “Stereo” in the
following cases:
– AVCHD playback
– Playback of secondary audio (including the
button click sound).
∫
HDMI Output Settings of Music Playback
Minimize the audio noise during music playback
by automatically switching the video output to
1080i.
∫
Settings for High Clarity Sound
Set a terminal that will stop processing audio
signals or whether or not to turn on/off the unit’s
display when “High Clarity Sound” (
>
28) is set to
“On (Video Off)” or “On (Video On)”.
≥
Set an option for video playback and audio
playback.
∫
Audio Delay
Synchronization between picture and sound is
corrected by adjusting the delay time of the audio
output.
∫
Analog Audio Output
Set this when outputting audio from the Analogue
AUDIO OUT terminal.
≥
If “7.1ch” or “2ch (Downmix)” is selected, audio
will not be output from the HDMI OUT terminal.
≥
When “7.1ch” is selected :
– Speaker presence and size
(
)
– Delay time (
)
– Channel balance (
)
To finish the speaker setting
Select “Complete”.
Audio
Value Electronics
Factory Direct Authorized Dealer
www.ValueElectronics.com
