- 24 -
Reference
HDR10+ Setting
You can set enable/disable of the HDR10+
function.
By changing this setting to “On”, you can use the
HDR10+ function under the following conditions:
– A device (TV, etc.) that supports HDR10+ is
– A disc that supports HDR10+ is played back.
y
The “Picture Settings” setting is disabled while
Advanced Settings
Press [OK] to show the following settings:
Colour Mode
This setting is for selecting colour-space
conversion of the image signal.
Deep Colour Output
Set the output method to be used when this unit
is connected to a TV that supports Deep Colour.
HDR/Colour Gamut Output
Set the output type for HDR (High Dynamic
Range) material.
Contents Type Flag
Depending on the playback content, the TV will
output adjusting to the optimal method when a
TV that supports this function is connected.
*1 It displays images at the highest resolution available on
your TV.
*2
A high resolution image/display technology of
approximately 4000 (width) x 2000 (height) pixels.
*3 A progressive image recorded at a rate of 24 frames
per second (motion-picture film). Many BD-Video movie
contents are recorded in 24 frames/second in accordance
with the film materials.
Sound
Dynamic Range Compression
You can listen at low volumes but still hear
dialogue clearly.
(Dolby Digital, Dolby Digital Plus and Dolby
TrueHD only)
y
“Automatic” is effective only when playing Dolby
TrueHD.
Digital Audio Output
Press [OK] to show the following settings:
Dolby Audio
DTS/DTS-HD
DSD Output Mode
Select the audio signal to output.
y
Select “PCM”, when the connected equipment
cannot decode the respective audio format.
This unit decodes the audio format and
transmits to the connected equipment.
y
If you do not make proper settings the audio
may be static or noisy.
y
“DSD Output Mode” is effective only when
connecting the unit with an HDMI cable.
y
When playing DSD 11.2 MHz format file
regardless of the settings for “DSD Output
Mode”, PCM signals are output from HDMI
terminal and
UB450
COAXIAL terminal.
BD-Video Secondary Audio
Select whether or not to mix the primary and
secondary audio (including the button click
sound).
If “Off” is selected, the unit outputs the primary
audio only.
UB450
HDMI Audio Output
This setting selects whether or not to output
audio from HDMI.
y
To enjoy audio with the HDMI terminal, select
“On”. To enjoy audio with the COAXIAL
terminal, select “Off”. Audio will not be output
from the HDMI terminal regardless of the
settings for “HDMI(VIDEO) Output Mode”.
y
To enjoy BD-Video that supports Dolby Atmos
®
or
DTS:X
®
Connect this unit to an AV amplifier or similar device that
supports it with an HDMI cable, and select the following
settings:
– Dolby Audio: “Bitstream”
– DTS/DTS-HD: “Bitstream”
– BD-Video Secondary Audio: “Off”
Dolby Atmos is a trademark of Dolby Laboratories.
Содержание DP-UB154
Страница 37: ... 37 Reference ...
