Panasonic DMP-BDT460, Руководство по эксплуатации

Страница: 30 / 40

30
SQT0099
∫
Quick Start
Speed of start-up from standby mode is
increased.
≥ When set to “On”, the internal control unit will be
powered and the idle power consumption will
increase so compared to when set to “Off”.
(Power consumption
>
35)
∫
Remote Control
Change the remote control code if other
Panasonic products react to this remote control.
∫ Firmware Update (
>
14)
Press [OK] to show the following settings:
¾ Automatic Update Check
When this equipment remains connected to the
Internet, it will check for the latest firmware
version when it is turned on and you can update
it if necessary.
¾ Update Now
You can update the firmware manually if a
firmware update is available.
∫
System Information
Press [OK] to show the following settings:
¾ Software Licence
Information about the software used by this unit
is displayed.
¾ Firmware Version Information
Display firmware version of this unit and
wireless LAN module.
∫ Default Settings
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
∫
Unit does not respond to remote
control or unit’s buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
∫
Cannot eject disc.
1
Turn the unit on.
2
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
4
Press [OK].
To return to the factory defaults.
¾ Select “Yes” in “Default Settings” in the Setup
menu. (
>
left)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1
Turn the unit on.
2
Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
4
Press and hold [OK] for more than 5 seconds.
∫ Start-up Banner
Select whether to display the banner after turning
on this unit. (
> 15)
This returns all values in the Setup menu and the
Option menu to the default settings, except for
some settings of network, ratings, remote control
code, on-screen language*, etc.
*
[Except[Australia[and[New[Zealand]
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (
>
14)
– Image disturbance when replacing 3D discs.
– “00 RET” is displayed on the unit’s display.
3
Press [
1
] (right) repeatedly on the remote
control until “06 FTO” is displayed on the
unit’s display.
General operation
– “00 RET” is displayed on the unit’s display.
3
Press [
1
] (right) repeatedly on the remote
control until “08 FIN” is displayed on the unit’s
display.
DMP-BDT460&360_EBGNGA-SQT0099.book 30 ページ ２０１４年１月２８日 火曜日 午後３時５７分