- 32 -
Cannot play.
¾
You inserted an incompatible disc.
Cannot play on this unit.
¾
You tried to play a non-compatible image.
¾
Re-insert the media.
No disc inserted.
¾
The disc may be upside down.
$
This operation is not available.
¾
Some operations are unsupported by the unit.
(For example, reverse slow motion, etc.)
IP address is not set.
¾
The “IP Address” in “IP Address / DNS
Settings” is “---. ---. ---. ---”. Set the “IP
Address”, “Subnet Mask”, and “Gateway
Address”. (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
¾
Set a stronger network security level referring
to the wireless router operating instructions.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
UPDATE
¾
The system is being restarted during the
firmware update. Please do not turn off the unit.
UPD
/
(“
” stands for a number.)
¾
The firmware is being updated.
Please do not turn off the unit.
FIN
¾
The firmware update is complete.
[For_the_South_East_Asia]
¾
Copying is complete.
Messages on the screen
Messages on the unit’s
display
NET
¾
While connecting to a network.
No PLAY
¾
There is a viewing restriction on a BD-Video
or DVD-Video. (
¾
The media is dirty or badly scratched. The
unit cannot play.
REMOVE
¾
The USB device is drawing too much power.
Remove the USB device.
SET
(“
” stands for a number.)
¾
The remote control and this unit are using
different codes. Change the code on the
remote control.
Press and hold [OK] and
the indicated number
button at the same time
for more than 5 seconds.
U59
¾
Temperature of this unit is hot and the unit
switches to standby for safety reasons.
Wait for about 30 minutes.
Install or place this unit with good ventilation.
H
or F
(“
” stands for a number.)
¾
There is something unusual.
¾
Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1
Disconnect the plug from the household
mains socket, wait a few seconds, then
reconnect it.
2
Press [
Í
/I] to turn the unit on.
