34
VQT3W08
Reference
Indicator illumination
Confirm the following items in correspondence to the status of the LED of the unit.
An error condition exists when the Status LED is red. Open the panel at the side of the main unit and
check the status of the indicator LEDs. If the red LED does not turn off even when following operation is
performed, contact your dealer.
Indicator LEDs
Description
The remote control and main unit are using different
codes. Remote control code may be changed when the
battery is changed. Reset the settings of the main unit
and the remote control to the states at the time of
purchase with following operation.
1
Turn the unit off once, and then turn it on again.
2
Touch and hold [
<
] on the main unit for more than 4
seconds while the HOME menu is displayed.
3
Press and hold [OPTION] and [G] at the same time
for more than 5 seconds.
Remote control code for the main unit and the remote
control will be set to “1”. Change the settings as
necessary. (
>
33, “Remote Control Code”)
The unit is carrying out an internal process. This is not a
malfunction. You cannot operate the unit while the light
is flashing. Wait for a while.
The unit fails to operate properly. Touch and hold [
Í
/I]
on the main unit for 3 seconds to switch the unit to
standby, then switch back on.
The USB device is drawing too much power. Please
disconnect or remove the USB device from the unit.
The USB device may be incompatible.
The unit is hot.
If the maximum operating temperature is exceeded the
unit automatically switches to standby.
In this case turn the unit off for approximately 30
minutes and make sure that there is adequate air flow
around the unit.
Red flashes for 6 times
The red or green light flashes slowly
Lights up
Flashes
Red lights up
Flashes
Lights up
Red lights up
Lights up
Red lights up
DMP-BBT01_VQT3W08 _eng.book 34 ページ ２０１２年４月６日 金曜日 午後３時０分
