Panasonic CZ-ANC2, Руководство по установке

Страница: 15 / 128

15
EN
(b) Zone registration using the system controller
In this case, you set all Central addresses by
system controller at once manually.
(1) Press the and buttons at the same time
for more than 4 seconds.
and CODE No. C1 will fl ash.
(2) After confi rming that CODE No. C1 is displayed,
press the button. Once in this mode, a change
takes place as Fig. 9.
(3) Select the zone and group No. which you want to
set with and (GROUP) buttons.
If already set, press the buttons.
(4) Set the unit No. (Indoor unit address) with and
buttons, according to the zone registration table.
R.C. No. ..................... button
Indoor unit No. ........... button
(5) Press the button.
GROUP No. turns ON and UNIT No. (Indoor unit
address) changes from fl ashing to ON state. UNIT
No. is registered to selected ZONE No. and GROUP
No.
If you make mistake, then press the button and
reselect the ZONE, GROUP and UNIT No.
(6) Register the other UNIT No. in the same way by
following the steps (3) to (5).
(7) Finally, complete the registration by pressing the
button.
fl ashes for a few minutes, then OFF.
If no data is
registered
no number
is displayed.
Selected
group No. if
no data is
registered.
If data is
registered
the unit No.
is displayed.
For example, in the case at left
Zone 3, group No. 7
Unit No. (indoor unit address) 2-8
Unit No. 2-8 is registered to zone 3-group 7.
Fig. 9
Fig. 10
CZ-ANC2̲eng.indd 15 CZ-ANC2̲eng.indd 15 2010/12/27 19:03:34 2010/12/27 19:03:34