4
1. General
This booklet briefl y outlines where and how to install the system controller.
Please read over the entire set of instructions for the indoor and outdoor
units and make sure all accessory parts listed are with the controller before
beginning.
NOTE
Give these instructions to the customer after fi nishing the installation.
Part Name
Figure
Q’ty
Remarks
System controller
1
Tapping screw
Truss-head
Phillips
4 × 16 mm
4
For securing the system
controller
Rawl plug
4
For securing the system
controller
Manual
1
For installation
1
For operation
2. Installation site selection
Install the system controller at a height of between 1 and 1.5 meters
•
above the fl oor.
Do not install the system controller in a place where it will be exposed to
•
direct sunlight or near a window or other place where it will be exposed to
the outside air.
Be sure to install the system controller vertically, such as on a wall.
•
3. How to install the system controller
CAUTION
Do not twist the control wiring together with the power wiring or
•
run it through the same metal conduit, because this may cause a
malfunction.
Install the system controller away from sources of electrical noise.
•
Install a noise fi lter or take other appropriate action if electrical
•
noise affects the power supply circuit of the unit.
Do not supply power to the unit or try to operate it until the tubing
and wiring to the outdoor unit is completed.
CZ-64ESMC2̲eng.indd 4
CZ-64ESMC2̲eng.indd 4
2010/12/24 16:58:33
2010/12/24 16:58:33
