ENGLISH
7
TROUBLESHOOTING
The following symptoms do not indicate malfunction.
The following symptoms do not indicate malfunction.
SYMPTOM
SYMPTOM
CAUSE
CAUSE
Mist emerges from indoor unit.
►
• Condensation effect due to cooling process.
Water
fl
owing sound during operation.
►
• Refrigerant
fl
ow inside the unit.
The room has a peculiar odour.
►
• This may be due to damp smell emitted by the wall,
carpet, furniture or clothing.
Indoor fan stops occasionally during automatic fan speed
setting.
►
• This helps to remove the surrounding odours.
Operation is delayed a few minutes after restart.
►
• The delay is a protection to the unit’s compressor.
Outdoor unit emits water/steam.
►
• Condensation or evaporation occurs on pipes.
Timer indicator is always on.
►
• The timer setting repeats daily once set.
Power indicator blinks before the unit is switched on.
►
• This is a preliminary step in preparation for the operation
when the ON timer has been set.
Cracking sound during operation.
►
• Changes of temperature cause the expansion/contraction
of the unit.
Inconsistent air
fl
ow during PATROL operation.
►
• Fan speed is adjusted automatically during patrol
operation.
Select QUIET operation to maintain the air
fl
ow
consistency.
Check the following before calling for servicing.
Check the following before calling for servicing.
SYMPTOM
SYMPTOM
CHECK
CHECK
Cooling operation is not working ef
fi
ciently.
►
• Set the temperature correctly.
• Close all doors and windows.
• Clean or replace the
fi
lters.
• Clear any obstruction at the air inlet and air outlet vents.
Noisy during operation.
►
• Check if the unit has been installed at an incline.
• Close the front panel properly.
Remote control does not work.
(Display is dim or transmission signal is weak.)
►
• Insert the batteries correctly.
• Replace weak batteries.
The unit does not work.
►
• Check if the circuit breaker is tripped.
• Check if timers have been set.
The unit does not receive the signal from the remote
control.
►
• Make sure the receiver not obstructed.
• Certain
fl
uorescent lights may interfere with signal
transmitter. Please consult authorized dealer.
Patrol sensor or e-ion indicator on the indoor unit is
blinking.
►
• Stop Patrol or e-ion operation then restart. If the patrol
sensor or e-ion indicator still blinking, please consult
authorized dealer.
Notes on “ECO PATROL SENSOR”
Notes on “ECO PATROL SENSOR”
• Sensor may not detect moving objects further than 7m away or beyond detection angle.
• Sensor sensitivity is in
fl
uenced by indoor unit location, movement speed, temperature range, etc.
• The sensor may mistakenly detects pets, sunlight, certain lighting,
fl
uttering curtains and light re
fl
ection as human being.
The unit stops and the timer indicator blinks.
Use remote control to retrieve error code.
TIMER
SET
CANCEL
ON
OFF
1
2
3
SET CHECK CLOCK
RESET
AC
RC
1
Press for 5
seconds.
3
Press for 5
seconds to
quit checking.
2
Press until you hear
beep sound, then
write down the error
code.
Note:
• For certain errors, you
may restart the unit for
limited operation with 4
beeps during operation
starts.
4
Turn the unit off and reveal the error code to authorized dealer.
