33
10. Installation Instruction
10.1 Select the Best Location
10.1.1 Indoor Unit
Do not install the unit in excessive oil fume area such as kitchen, workshop and etc.
There should not be any heat source or steam near the unit.
There should not be any obstacles blocking the air circulation.
A place where air circulation in the room is good.
A place where drainage can be easily done.
A place where noise prevention is taken into consideration.
Do not install the unit near the door way.
Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.
Recommended installation height for indoor unit shall be at least 2.5 m.
10.1.2 Indoor Unit Installation Diagram
d
n
e
b
o
t
t
o
n
n
o
it
n
e
tt
A
n
o
it
c
e
ri
d
g
n
i
p
i
P
up drain hose
(Front side)
Right
Rear
Right
Right
bottom
Left
Rear Left bottom
Left
Vinyl tape
Remote control holder fixing screws
6
Remote control holder
5
Remote
control
3
• This illustration is for explanation purposes only.
The indoor unit will actually face a different way.
• Respective outdoor unit installation procedure shall
refer to instruction manual provided in the outdoor
unit packaging.
It is advisable to avoid more than 2 blockage
directions. For better ventilation & multiple-
outdoor installation, please consult authorized
dealer/specialist.
• Carry out insulation after
checking for gas leaks and
secure with vinyl tape.
Attaching the remote control holder to the wall
Insulation of piping connections
50 mm
or more
5
0
m
m
o
r
m
o
re
(Left and right are identical)
Installation plate
1
Sleeve ( )
Bushing-Sleeve ( )
Bend the pipe as
closely on the wall as
possible, but be careful
that it doesn’t break.
Saddle ( )
Putty ( )
(Gum Type Sealer)
Vinyl tape (wide) ( )
• Apply after carrying
out a drainage test.
• To carry out the
drainage test,
remove the air
filters
and pour water into
the heat exchanger.
Installation parts you
should purchase (
)
