Panasonic CR-W402UA, Руководство по эксплуатации

Страница: 3 / 24

3
CR-W402UA
Caution
Observe the following cautions when handling
this unit.
❑
Keep the sound volume at an appropriate level.
Keep the volume level low enough to be aware of road and
traffic conditions while driving.
❑
This unit is designed for use exclusively in
automobiles.
❑
Do not operate the unit for a prolonged period with
the engine turned off.
Operating the audio system for a long period of time with the
engine turned off will drain the battery.
❑
To ensure safety, never attempt to preset stations
while you are driving.
❑
Depending upon the transmission condition of
electro-magnetic waves, the geographical reasons
and/or the weather conditions, you may not receive
the NOAA radio partially or at all.
❑
Make sure that your weather radio can receive
properly before driving, especially, before use in a
critical condition.
Observe the following cautions when
installation.
❑
Refer wiring and installation to qualified service
personnel.
Installation of this unit requires special skills and experience.
For maximum safety, have it installed by the shop where you
purchased it. Panasonic is not liable for any problems
resulting from your own installation of the unit.
❑
Follow the instruction to install and wire the
product.
Not following the instructions to properly install and wire the
product could cause an accident or fire.
❑
Take care not to damage the leads.
When wiring, take care not to damage the leads. Prevent
them from getting caught in the vehicle chassis, screws, and
moving parts such as seat rails. Do not scratch, pull, bend or
twist the leads. Do not run them near heat sources or place
heavy objects on them. If leads must be run over sharp
metal edges, protect the leads by winding them with vinyl
tape or similar protection.
❑
Use the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools
to install the product. The use of parts other than those
supplied or designated may result in internal damage to the
unit. Faulty installation may lead to an accident, a
malfunction or fire.
❑
Do not block the air vent or the cooling plate of the
unit.
Blocking these parts will cause the interior of the unit to
overheat and will result in fire or other damage.
❑
Do not install the product where it is exposed to
strong vibrations or is unstable.
Avoid slanted o strongly curved surfaces for installation. If
the installation is not stable, the unit may fall down while
driving and this can lead to an accident or injury.
❑
Installation Angle
The product should be installed in a horizontal position with
the front end up at a convenient angle, but not more than 30˚.
The user should bear in mind that in some areas there may
be restrictions on how and where this unit must be installed.
Consult your dealer for further details.
❑
Wear gloves for safety. Make sure that wiring is
completed before installation.
❑
To prevent damage to the unit, do not connect the
power connector until the whole wiring is
completed.
❑
Do not connect more than one speaker to one set of
speaker leads. (except for connecting to a tweeter)
The following applies only in the U.S.A.
Part 15 of the FCC Rules
FCC Warning:
This device complies with Part 15 of the FCC Rules for
Radio Receiver. Operation is subject to the condition that
this device may not cause harmful interference. Any
unauthorized changes or modifications to this equipment
may void the user's authority to operate this device.
Accessories 1. Operating Instructions ......................................................................................1
2. Supplied Hardware .................................................................1 set (
a
page 18)
3. Product Registration Card.................................................................................1
4. Customer Care Plan ..........................................................................................1
CR̲W402UA̲01̲eng.qxd 08.12.5 11:41 AM ページ3