CR-W402U
17
CR-W402U
16
❐
Preparation
❐
Installation Hardware
Warning:
If your vehicle is equipped with air bag
and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic
component, contact your vehicle dealer or
manufacturer to determine the required procedure
and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.
Caution:
Various settings that have been stored in
the memory in other on-board equipment (vehicle
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or to
back up the settings before disconnecting the
terminals.
After completing installation of the main unit, set the
equipment again according to the record.
• Disconnect the cable from the negative
battery
terminal (see warning and caution below).
• Remove Mounting Collar
q
from the main unit
temporarily, which are already mounted at shipment.*
• Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30˚.
❐
Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an
opening as shown below. The dashboard should be
3/16” (4.75 mm) – 7/32” (5.56 mm) thick in order to be
able to support the unit.
Q’ty
Item
No.
Diagram
q
1
Mounting Collar*
Plain washer (5mmø)
w
2
Spring Washer (5mmø)
e
2
Hex. Nut (5mmø)
r
2
Rear Support Strap
t
1
Hex. Bolt
(5mmø
×
25 mm)
y
1
Toothed Lock Washer
(5mmø)
u
1
Removal Tool
(U-shaped)
i
2
Power Connector
o
1
Mounting bolt
(5 mmø)
q
Mounting collar
Rear support bracket
(provided on the vehicle)
Rubber cushion (option)
(a) Using the rear support strap
t
(b) Using the rubber cushion (option)
Installation
(Continued)
1
2
3
Cautions:
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands
and fingers.
First complete the electrical connections, and then check them for correctness.(
a
page 18)
The included Mounting Collar
q
is designed specially for this unit. Do not use it to attach any other model.
Insert Mounting Collar
q
into the
dashboard, and bend the mounting tabs
out with a screwdriver.
Establish the rear connection of the unit.
After fixing Power Connector, fix the rear of the unit
to the vehicle body by either method (a) or (b)
shown in the previous page.
After installation reconnect the negative
(–) battery terminal.
The tabs to be bent vary depending
on the vehicle. To securely install
the unit, fully bend a number of the
tabs so that there is no rattling.
Example:
Tab
q
Mounting
Collar
Mounting Holes
Mounting Bolt
Power Connector
Mounting springs (
C
)
Engage the Mounting
Springs (
C
) in the
mounting holes of the
Mounting Collar
q
firmly.
Mounting Spring
Mounting
Hole
❐
To Remove the Unit from the vehicle's dashboard
Insert each Removal Tool
i
and pull.
i
Removal Tool
(U-shaped)
Note:
Do not lose Removal Tools. They
will be needed to remove the unit from the
vehicle's dashboard.
CR_W402UOIeng_M 12/22/2005 12:31 PM 頁面 16
