54
CQ-CB9900U
CQ-CB9900U
55
Installation Guide
(continued)
Installation Procedures
The included mounting collar
1
is designed
specifi cally for this unit. Do not use it to attach
any other model.
6
Power
connector
Engage the mounting
springs (
§
) in the
mounting holes of the
mounting collar
1
fi rmly.
The tabs to be bent vary depending on
the car. To securely install the unit, fully
bend a number of the tabs so that there is
no rattling.
(b) Using the rubber cushion (option)
1
Insert mounting collar
1
into the
dashboard, and bend the mounting tabs out
with a screwdriver.
2
Secure the rear of the unit.
After fi xing mounting bolt
5
and power
connector
6
, fi x the rear of the unit to the
car body by either method
(a)
or
(b)
shown
below.
3
Insert trim plate
7
.
4
After installation,
reconnect the
negative
-
battery
terminal.
Mounting holes
Mounting
springs (
§
)
5
Mounting bolt
Mounting springs (
§
)
Mounting
hole
(a) Using the rear support strap
3
4
Tapping screw
Fire wall of car
2
Hex. nut
3 mm
‡
3
Rear support strap
5
Mounting bolt
1
Mounting collar
Rubber cushion (option)
Rear support bracket
(provided on the car)
5
Mounting bolt
1
Mounting collar
Tab
First complete the electrical connections, and then
check them for correctness (page 56).
Example:
Remove the
mounting collar
1
and the trim plate
7
from the main unit
temporarily, which
are already mounted
at shipment.
8
Lock cancel plate
Remove the Unit
Switch off the power of the unit.
1
Remove the removable face plate (page 49).
2
Remove the trim plate
7
with a screwdriver.
3
1
Insert the lock cancel plates
8
along the
grooves on both sides of the main unit
until “click” is heard.
2
Pull out the unit while pushing the plates
further inside.
4
Remove the unit pulling with both hands.
7
Trim plate
1
Insert.
Insert the tab
end in the
outer groove.
Screwdriver
2
Pull out.
“Click”
