Panasonic CQ-VA7300N, Руководство по эксплуатации

Страница: 24 / 35

47
45
E
N
G
L
I
S
H
46
E
N
G
L
I
S
H
CQ-VA7300N CQ-VA7300N
46
Installation
(continued)
Use the supplied Spacer i if mounting hole of your car is shaped like below.
i Spacer
o
Double-Faced Adhesive Tape
t Binding-Head Screw
(5
mm
ø x 6 mm)
Not used
Bracket
Mounting Hole
of a Bracket
(in section)
Existing Bracket (L)
(Bracket originally
attached to the car)
o Double-Faced
Adhesive Tape
Existing Bracket (R)
t
Binding-Head Screw
(5 mm ø x 6 mm)
i
Spacer
❏
Installation Procedures (When not using Mounting Collar
w
)
Use the brackets supplied with your car when mounting this unit. The bracket shape and mounting method vary with car
manufacturers, car types and manufacturing year. Please consult your nearest dealer or installer.
Select mounting screws according to the hole positions and hole shape of the bracket.
y Flat-Head Screw (5
mm
ø x 6 mm) 4 pieces
u
Binding-Head Screw (4 mm ø x 3 mm)
4 pieces
t
Binding-Head Screw (5 mm ø x 6 mm) 2 pieces
Recycle the Binding-Head Screws that fixed the transportation brackets for two more
positions.
When using these
mounting holes
Attach the seal side of the Velcro Tape
!6
to the hide-away unit, then mount the unit
on the carpet.
Note: Some carpet materials may not be
suitable for this mounting method. In this
case, please contact your nearest
Panasonic Service Center for installation.
❑
Mount the unit on the car carpet by using Velcro Tape !6 .
Mounting the Hide-away Unit
Cautions:
¡ Never mount the unit in any of the following locations to avoid damage due to overheating;
1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
¡ Do not mount the unit near the door, where it could be exposed to rain.
!6
Velcro Tape
❑
Unit installation by using the Mounting Brackets
!3
and the Base Brackets
!4
.
!2 Hex. Nut (5
mm
ø)
Carpet
!3
Mounting Bracket
!0
Binding-Head Screw
(5
mm
ø x 8 mm)
!1
Tapping Screw (6 mm ø x 20 mm)
!5
Double-Faced Adhesive Tape
Drill for 4.8 mm diameter holes to the chassis.
* Put the tape and the base bracket together with each hole of the tape and
bracket connected so that the screw goes in at two positions.
!4 Base Bracket
Note: Apply an anticorrosive to the holes and tapping screws.
Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.
Make cuts by using cutter.
Let the bolts of the base bracket
pass the carpet.