No operation by some cause.
➡
Press [RESET] on the CD changer (optional).
Disc has scratches.
➡
Select the next available compact disc.
≥
Disc is dirty, or is upside down.
≥
A disc other than a music CD (CD-DA type) is loaded.
➡
Select the next available compact disc.
No operation by some cause.
➡
Turn off the car engine (ACC off) and remove the fuse from the battery lead
(yellow) for 1 minute. Then reinstall the fuse.
Remote control is in the wrong direction.
➡
Direct the remote control at sensor (REMOTE) on the panel.
Battery has run down.
➡
Replace the battery.
Wrong the battery.
➡
Check the battery.
Battery poles (
i
) (
j
) are reversed.
➡
Insert the battery correctly.
E
N
G
L
I
S
H
CQ-DF302W
29
E
N
G
L
I
S
H
19
CQ-DF302W
28
Troubleshooting
(Continued)
E
N
G
L
I
S
H
20
Error Display Messages
❐
CD
Disc has scars.
➡
Press [OPEN] to open the front panel, and then press [
<
] (EJECT) to eject
the disc.
≥
Disc is dirty, or is upside down.
≥
A disc that has data other than CD-DA type is loaded.
➡
Press [OPEN] to open the front panel, and then press [
<
] (EJECT) to eject
the disc.
Display
Cause/Step
❐
CD Changer
No disc in the changer (magazine).
➡
Insert discs into the changer (magazine).
Notes:
≥
There may be cases where the disc numbers affected by an error are displayed before “E1” or “E2”.
≥
Displays and the steps to be taken for errors vary in part from changer to changer. For details, refer to the
operating instructions for the changer used.
DISC No.
DISC No.
≥
Disc is dirty.
≥
Disc has scratches.
➡
Clean disc, referring to the section on “Notes on CD/CD media (CD-R,
CD-RW)”.
Mounting angle is over 30
o
.
➡
Adjust mounting angle to less than 30
o
.
Instable mounting.
➡
Mount the unit securely with the mounting parts, referring to the section on
installation.
≥
Disc is defective.
≥
Mechanical trouble.
➡
Press [OPEN] to open the panel and press [
<
] (EJECT). If normal operation
is not restored yet, call the store where you purchased the unit or the near-
est Servicenter to ask for repairs.
Sound skips, bad sound
quality (e.g. caused by
noise)
Sound skips due to vibra-
tion.
Disc is not ejected.
The first track of a mix mode disc was reproduced. (Mix mode is a format in
which data except music is recorded on the first track and music data is recorded
on other than the first track in a session.)
➡
Play back music data recorded on other than the first track.
Time is counted but no
sound comes out.
Disc is in the CD compart-
ment but no sound is
made, or disc is ejected
automatically.
Disc is upside down.
➡
Place disc in the correct direction, and the label side up.
❐
CD
≥
Disc is dirty.
≥
Disc has scratches.
➡
Clean disc, referring to the section on “Notes on CD/CD media (CD-R,
CD-RW)”.
A disc that has data other than CD-DA type is loaded.
➡
Discs that have CD-DA type data should be used.
➡
The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a disc
which are incompatible one another. Refer to instructions for the concerned
devices for details.
➡
The unit may not successfully play back a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a disc
which are incompatible one another. Refer to instructions for the concerned
devices for details.
Trouble
Cause/Step
Trouble
Cause/Step
No sound from left, right,
front or rear speakers.
Left and right balance, or front and rear balance is off on one side.
➡
Adjust balance/fader mode as appropriate.
❐
Sound Setting
The right speaker wire is connected to the left speaker and the left speaker wire
to the right speaker.
➡
Connect the speaker wires to the correct ones.
Left and right sounds are
reversed in stereo listen-
ing.
Buttons are invalid for
operation.
❐
Remote Control
Cables are not correctly connected.
➡
Connect the cables correctly.
