8
6
Select [1. Initialize and restore the HDD], press .
7
At the confirmation message, press .
8
When the message "Remove a floppy disk from the
SuperDisk drive, and turn the computer off. Replace
the SuperDisk drive with a CD-ROM drive. Then, fol-
low the instructions in the manual." is displayed, fol-
low on-screen instructions.
(1)Replace the SuperDisk drive with the CD-ROM drive.
(2)Turn the computer on.
(3)When the message [Press <F2> to enter SETUP] is
displayed, press and then run the Setup Utility.
(4)Press
F9
.
At the confirmation message, select [Yes] and press
Enter
.
(5)Select [Boot] menu, press
F5
/
F6
and /
until [CD-ROM/DVD-ROM] is at the top of the
[Boot] menu and [ATAPI Removable] is the next
position.
(6)Select [Power] menu and set [Power Management]
to [Disable] , [Power Switch] to [Off] and [Fn + F7/
Fn + F10 key] to [Disable].
(7)Insert the Windows NT 4.0 Workstation CD-ROM.
(8)Press
F10
. At the confirmation message, select
[Yes] and press
Enter
. The computer will reboot.
9
At the [Welcome to Setup], press
Enter
.
10
At the [Setup has recognized the...], press
Enter
.
If the message [Setup has determined that...] is dis-
played, press
Enter
.
Reinstalling
CAUTION
If data on your hard disk is compressed, the data should
be uncompressed.
Windows NT
(reinstalling)
1
Replace the CD-ROM drive with a SuperDisk drive.
Insert the Tool Disk, and turn the computer on.
2
When the message [Press <F2> to enter SETUP] is dis-
played, press
F2
and then run the Setup Utility.
3
Press
F9
.
At the confirmation message, select [Yes] and press
Enter
.
4
Select [Power] menu and set [Power Management] to
[Disable] , [Power Switch] to [Off] and [Fn + F7/Fn +
F10 key] to [Disable].
5
Press
F10
. At the confirmation message, select
[Yes] and press
Enter
. The computer will reboot
and this screen should appear.
1. Initialize and restore the HDD
2. Exit
Reinstalling Software
Before Reinstallation
Preparing
Important
FIRSTAID CD
Windows NT Workstation CD-ROM included in the Windows NT Workstation System Pack
Windows NT Service Pack 5 CD-ROM
Tool Disk you made earlier
If you have not created the Tool Disk, you can create by selecting [Create Tool disk] in [Start] - [Programs] -
[Panasonic]. If you can not create this disk, please contact Panasonic Technical Support.
NOTE
The SuperDisk Drive Pack (CF-VFS371) is required for the following reinstallation procedure.(
"SuperDisk
Drive")
Save all important data. If reinstallation is carried out, all data existing prior to the installation will be lost. The
reinstallation will return the computer to close to the conditions at time of purchase.
Before the reinstallation procedure, remove all peripherals (except for the SuperDisk drive).
Be sure the AC adapter is connected until the reinstallation procedure is completed.
When the computer enter the ECO mode, the computer to the LCD is automatically cut. In this case, perform the touch
pad operation.
Enter
Enter
F2
