9
Installation Instructions
How to install and connect the unit
(continued)
2
Mount the mount bracket onto the installation surface.
●
Use the bracket mounting screws [M4, bind-head: 10 mm (13/32 inches) long] supplied with the unit.
●
For proper clamping torque, securely attach the screws using the specified tools.
Screw diameter
Clamping torque
M4
1.47 N · m {15
kgf
· cm}
Bracket mounting screws x 4 (supplied)
(M4, bind-head)
●
Use only the screws supplied with the unit. Do not use any other screws such as wood screws, nails, etc.
Note
3
Attach the drop-prevention wire.
●
Pull out the drop-prevention wire from the bottom panel of the unit, and engage the end with the wire ring through the
hole of the mount bracket hook.
●
Pull the drop-prevention wire, and check that it has been attached securely to the hook.
Pull out the drop-prevention wire, and
engage it with the mount bracket hook.
End of hook
Drop-prevention wire
Holding spring
●
Do not do this work while holding the camera head since doing so may result in malfunctioning of the unit.
●
The drop-prevention wire is designed to be used for installation where the unit is suspended from an overhead
surface so do not subject it to the weight of units other than the unit.
Notes
