Panasonic AW-HEA10KEJ, Инструкция по установке и эксплуатации

Страница: 11 / 40

Installation Instructions
4.
Mount the unit.
• Align the hole for checking the positioning of mount bracket B with the positioning mark of the unit.
• Align the bottom insertion holes of the unit with the camera insertion protrusions of the mount bracket and then push the unit and bracket together
firmly and rotate the unit by approx. 20° in the direction of the arrow.
• Secure the unit and mount bracket B with the supplied bracket mounting screw B (M3 x 6 mm).
Bracket mounting screw B (M3×6 mm)
Positioning mark
Approx.
20°
On the unit:
Bottom insertion holes
(3 places)
On the mount
bracket:
Camera insertion
protrusions (3
places)
Hole for checking
the positioning
<NOTE>
• Use only the screws supplied. Do not use any other screws.
• Check that the unit has been mounted securely with no tilting or wobbling.
• Be sure to secure the unit and bracket with the bracket mounting screw B before connecting any of the cables.
5.
Check the mounting.
Check out the following points.
• The bracket mounting screw B must be attached properly.
• The unit must not tilt, and it must be mounted exactly.
• The unit must be securely installed.
6. Connect the rear panel connectors.
Anchor the AC adaptor cable in place using the cable clamps.
INIT
LINK/
ACT
100BT
USB 2.0 5.0V IN
DEVICE
10BASE -T/
100BASE- TX
AC adaptor cable
Cable clamp
<NOTE>
• Two cable clamps are available: one at the top and one at the bottom of the connector panel. Use the most suitable method depending on the
installation method and positioning of the cable.
10 11
How to install and connect the unit (continued)