Panasonic AV-HS60C3G, Руководство по эксплуатации

Страница: 117 / 176

– 117 –
Chapter 7 Configuring Operations — Setting the source link
Setting the source link
Setting the key coupling
Linking the key fill signal and key source signal
If you select key fill signal or key source signal using the key bus crosspoint buttons of the control panel, the signals are linked and the other signal is
automatically selected.
The unit’s linking operation has two modes.
f
[Fill to Source]: When the key fill signal (master) is selected, the key source signal (slave) changes automatically.
f
[Source to Fill]: When the key source signal (master) is selected, the key fill signal (slave) changes automatically.
1
Select the <OPR> button
→
[SOURCE LINK]
→
[Key Assign] tab.
2
Select an item in [Master/Slave].
[Fill to Source] Links the key fill signal (master) to the key source signal (slave).
[Source to Fill] Links the key source signal (master) to the key fill signal (slave).
3
Select the item to be set as the master from the left column.
f
Select [Master Filter] to filter the master list in the left column.
4
Select the item to be set as the slave from the right column.
f
Select [Slave Filter] to filter the slave list in the right column.
5
Select [Assign].
f
Make the coupling setting for the source selected as the master and the source selected as the slave.
f
If [Self] is set to [On] and [Assign] is selected, the same source selected for the master is coupled, regardless of the selection status of the slave.
@ @ NOTE
t
When the [Master/Slave] settings are changed, the coupling setting is initialized.
Linking the AUX bus
Two AUX buses can be linked by the setting in “Setting the key coupling”.
f
The coupling combinations are the odd AUX signals and the subsequent even AUX signals, such as AUX1 and AUX2 or AUX3 and AUX4.
Linking the odd AUX signals and even AUX signals
1
Select an item in [AUX1/2 Link] to [AUX15/16 Link] in the [Link] column.
[OFF] Disables the coupling setting.
[ON] Enables the coupling setting.
@ @ NOTE
t
When the [Master/Slave] settings are changed, the coupling setting is initialized.