15
IEEE1394b Driver for Windows
(continue)
2) Installation of the IEEE1394b
driver
Install the IEEE1394b driver in accordance with
the following procedures.
<Note>
The IEEE1394b driver is installed for each unit
connected to a personal computer. If you use
more than one unit on a single personal
computer, install the drivers for the respective
units separately. If the IEEE1394b driver are not
installed, a sufficient transfer rate may not be
obtained.
1
In accordance with the descriptions in “4.
Installation of the P2 Software” (from pages
5 to 8 of the installation manual), install the
software up to Procedure No. 9.
2
When the window shown in Figure 9 of
Procedure No. 9 (page 8 in the installation
manual) is displayed, select “AJ-PCD20 (P2
drive) 1394 driver” and then click OK.
3
When the message “Please connect AJ-
PCD20 (P2 drive) by 1394” is displayed,
connect this unit to the personal computer
using IEEE1394b. Confirm that all five drive
letters of this unit are displayed and then
press Install.
<Note>
When the unit is connected to a personal
computer through USB, remove the USB
cable and then connect using IEEE1394b.
4
The warning box may be displayed; in such a
case, click “Continue Anyway”. The warning
box may be displayed two or more times.
5
In accordance with the instructions on the
screen, complete the installation and restart
the personal computer.
3) Confirmation of installation of the
IEEE1394b driver
When using IEEE1394b, only one AJ-PCD20
can be connected to the personal computer. If
two or more AJ-PCD20 units are connected
simultaneously, operations cannot be
guaranteed.
With Windows 7
Before installing the IEEE1394b driver, make
the following settings.
Otherwise, operation may become unstable.
1
Click “Start”, right-click “Computer”, and
select “Property” to display the system
properties. Then click “Device manager” at
the top-left corner of the window.
2
Right-click “
¢¢¢¢
1394 OHCI Compliant
Host Controller” under “IEEE 1394 bus host
controllers” (“
¢¢¢¢
” may be replaced with
a device name), and select “Update Driver
software...”.
3
Select “Browse my computer for driver
software”, and click “Let me pick from a list
of device drivers on my computer”.
4
Select “1394 OHCI Compliant Host
Controller (Legacy)” in the displayed driver
list, and click “Next” to complete
installation.
5
Repeat the above settings for all “1394
OHCI Compliant Host Controller” under
“1394 bus host controller”, if they exist.
AJ-PCD20P_E_EJ(VQT0X89-8)_E.book 15 ページ ２０１３年３月１８日 月曜日 午後２時７分
