Panasonic AJ-CX4000G, Руководство по эксплуатации

Страница: 203 / 221

– 203 –
Chapter 10 Maintenance — Warning system
Warning system
If an error is detected immediately after the camera is turned on or during an operation, the error is indicated with the <WARNING> lamp, tally lamp,
alarm, etc. Deal with the error by following the indications.
Warning list
@ @
NOTE
t “Reduced wireless audio reception” (page 204) is not displayed when set to the [AUDIO] menu → [INPUT SETTINGS] → [WIRELESS WARN] →
[OFF].
t Card access lamp does not flash even a warning occurs when set to the [OTHERS] menu → [LED] → [ACCESS LED] → [OFF].
1 System error
Status display Does not display.
Warning lamp Flashes four times per second.
Tally lamp Flashes four times per second.
Card access lamp All card access lamps flash four times per second in orange.
Viewfinder [SYSTEM ERROR] is displayed.
Alarm Sounds continuously.
Warning content Reference signal error or communication error.
Recording or playback operation The current operation will stop.
Action to take Consult your dealer.
2 Card removal error
Status display Does not display.
Warning lamp Flashes four times per second.
Tally lamp Flashes four times per second.
Card access lamp All card access lamps flash four times per second in orange.
Viewfinder [TURN POWER OFF] is displayed.
Alarm Sounds continuously.
Warning content An error occurred in the camera because the expressP2 card being accessed was removed.
Recording or playback operation The current operation will stop.
Action to take
Follow the message to turn the power off once and turn the power on again. Ensure that there is no error in the clips on
the ejected card, and repair the clips as necessary.
3 Battery end (low voltage input)
Status display Seven battery charge level bars flash.
Warning lamp Lights.
Tally lamp Flashes four times per second.
Card access lamp All card access lamps flash four times per second in orange.
Viewfinder
The [BATT] lamp is illuminated if the viewfinder has the [BATT] lamp. [EMP] flashes in the battery charge level display.
([%] flashes for batteries with information about its remaining capacity.)
Alarm Sounds continuously.
Warning content The battery has run out.
Recording or playback operation The current operation will stop. The power is turned off in approximately five seconds.
Action to take Change the batteries.
4 High temperature error
Status display
Does not display.
Warning lamp Flashes four times per second.
Tally lamp
Flashes four times per second.
Card access lamp All card access lamps flash four times per second in orange.
Viewfinder
[HIGH TEMPERATURE] is displayed.
Alarm Sounds continuously.
Warning content
The internal temperature of the camera has risen exceeding the expectation.
Recording or playback operation The current operation will stop. The power is turned off in approximately five seconds.
Action to take Turn on the power again and confirm the recording by playing it back. If the problem persists, consult the dealer.
5 Card end
Status display Seven remaining memory card capacity level bars flash.
Warning lamp Lights.
Tally lamp Flashes four times per second.
Card access lamp All card access lamps flash four times per second in orange.
Viewfinder [END] is displayed in the remaining memory card capacity display.
Alarm Sounds continuously.
Warning content
There is no more remaining memory card capacity.