– 204 –
Chapter 10 Maintenance — Warning system
Recording or playback operation
Recording will stop.
Action to take
Delete clips in the memory card or insert a new memory card.
6
Recording error
Status display
Does not display.
Warning lamp
Flashes four times per second.
Tally lamp
Flashes four times per second.
Card access lamp
All card access lamps flash four times per second in orange.
Viewfinder
[REC WARNING] is displayed.
f
[REC WARNING]/[<OVER MAX NUM. OF CLIPS>] is displayed when you try to record exceeding the limit for number
of clips.
f
[TEMPORARY PAUSE]/[IRREGULAR SIG] is displayed when the genlock reference signal is not correctly received.
Alarm
Sounds four times per second.
Warning content
This is a recording or recording circuit setting error.
Recording or playback operation
Recording will stop. When the reference signal for genlock is not correctly received, pause the recording, and resume
the recording when the signal returns to normal.
Action to take
Start recording again. Or, turn the power off once and then start recording again.
To record exceeding the maximum numbers of the clips, replace the memory card or delete unnecessary clips.
7
Card error
Status display
Does not display.
Warning lamp
Flashes four times per second when occurring during recording.
It does not illuminate when it occurs during playback.
Tally lamp
Flashes four times per second when occurring during recording.
It does not illuminate when it occurs during playback.
Card access lamp
All card access lamps flash four times per second in orange when occurring during recording.
Viewfinder
Displays [CARD ERROR <SLOT 1>] (corresponding card slot number is displayed).
Alarm
Sounds four times per second when occurring during recording.
It does not sound when it occurs during playback.
Warning content
A memory card error occurred during recording or playback.
Recording or playback operation
The current operation will stop. The memory card with the error is write-protected after it is stopped.
Action to take
Replace the memory card.
8
Reduced wireless audio reception
Status display
Does not display.
Warning lamp
Flashes four times per second. (When idle or during recording)
Tally lamp
Flashes four times per second while recording is continued.
Viewfinder
[WIRELESS RF] is displayed.
Alarm
Sounds four times per second while recording is continued.
Warning content
The error indicates poor wireless audio reception conditions.
Recording or playback operation
The current operation will continue.
Action to take
Check the microphone power supply and the reception status of the receiver.
9 Battery near end
Status display
One battery charge level bar flashes.
Warning lamp
Flashes once per second.
Tally lamp
Flashes once per second.
Viewfinder
The [BATT] lamp flashes once per second if the viewfinder has the [BATT] lamp. ([%] indication flashes if the battery has
information of remaining capacity.)
Alarm
Sounds four times per second.
Warning content
The battery is about to run out.
Recording or playback operation
The current operation will continue.
Action to take
Change the batteries as needed.
10
Memory card recording near end
Status display
One remaining memory card capacity level bar flashes.
Warning lamp
Flashes once per second while recording is continued.
Tally lamp
Flashes once per second while recording is continued.
Viewfinder
The remaining memory card capacity indicator flashes.
Alarm
Sounds once per second while recording is continued.
Warning content
The remaining memory card capacity totals 2 minutes or less.
Recording or playback operation
The current operation will continue.
Action to take
Change the memory card or insert an additional card as needed.
Содержание AJ-CX4000G
